Paradyne 1740 SHDSL manual PPPoE

Page 22

1740 SHDSL 2/4-Wire Router User’s Guide

STEP 4: Click Save & Reboot on the Basic menu bar to save your settings.

3.2.3PPPoE

When a VC is set in the PPPoA, the router will auto-detect the Authentication code (PAP or CHAP). The NAPT and DHCP server functions will be enabled automatically.

STEP 1: Click WAN Setup on the Basic menu bar and enter the following parameters to set up the PPPoE.

VPI	Enter a value for the vitual path identifier

VCI	Enter a value for the virtual channel identifier

LLCEncapsulation:	With LLC encapsulation, a link control header is added to the
	Ethernet packet that identifies the protocol type (Ethernet). This
	allows multiple protocols to be transmitted over the ATM Virtual
	Circuit.

VC Multiplexing:	With VC Multiplexing, no link control header is needed as the ATM
	Virtual Circuit is assumed to be carrying a single protocol.

Enable NAPT	Selecting Enabling NAPT will enable Network Port Address
	Translation on the WAN interface.

User Name/Password	These two fields are used for remote subscriber to log on for
	Internet access.

Mode	Direct and Auto. If the mode is set to Auto, the PPPoE negotiation
	automatically starts when the system identifies any traffic required
	to be transferred on the link. When DIRECT is selected the PPPoE
	negotiation is started manually.

22

July 2004

1740-A2-GB20-00

Image 22

Contents Shdsl July 1740-A2-GB20-00 July Table of Contents Chapter Application Example Appendix a Specifications Overview ApplicationLED Indicators Color Mode FunctionAC power adapter InstallationPreparing for Hardware Installation Four-wire 8P8C straight-through RJ45 cableDSL connection Power connectionRear-panel Connections Ethernet connectionQuick Installation LoginJuly Web Page Layout Monitoring the Shdsl Line WAN Interface Configuration Bridge Mode Service for One Fixed IP Address VCI1740-A2-GB20-00 July Router Mode Service for Five Static IP Addresses 1740-A2-GB20-00 July July 1740-A2-GB20-00 July PPPoE Shdsl 2/4-Wire Router User’s Guide PPPoA 1740-A2-GB20-00 July Password Setup Setting the Bridge Spanning Tree ProtocolStatic Bridging Write System Configurations Load Factory Default Values Setting up WAN and LAN Interfaces LAN InterfaceConfiguring the WAN Interface VC Data Flow Control Setting up an ISP Enable Snmp SnmpDisable Snmp Packet Filter Add a Packet Filter entryEnable/Disable Packet Filter Delete a Packet Filter entryAdd RoutingStatic Route ModifySet Up the RIP function 1740-A2-GB20-00 July Displaying the Routing Table NAT Multiple to One One to One NAT Multi-NAT 1740-A2-GB20-00 July Virtual Server Dhcp Dhcp ServerDhcp Relay DNS Proxy Igmp Click Apply to submit the settings Vlan Parameters and buttonsMaintenance and Diagnostics Software Upgrade and Configuration Backup /RestorationJuly 1740-A2-GB20-00 July OAM Loopback Ping Performance Monitoring 1740-A2-GB20-00 July Interface Application Example Adding the Static Route WebJuly Pin Assignments Line Port RJ45VT100 Compatible Terminal Console AccessConsole Port Cable Keyboard Operations July Motoring the Shdsl Line Status Retrieve the Factory Default Settings Disable the Web BrowserSave the Configurations July Appendix a Specifications Network functions Power SupplyEnvironmental Conditions