Paradyne 1740 SHDSL manual Password Setup

Page 26

1740 SHDSL 2/4-Wire Router User’s Guide

3.2.5Password Setup

There are two types of access privileges. A system ADMINISTRATOR is the only person that can configure, change parameters, monitor, and read the performance and status of the system. A USER can only monitor and read the status of the system. The password for access through the Web is the same as for Telnet access.

To set up a password, complete the following steps:

STEP 1 Click Change Password on the Basic menu bar.

STEP 2 Enter the passwords for Administrator and User, and confirm the new password by re-typing the password again.

STEP 3 Click Apply to complete the settings and save the setting by entering the Save & Reboot screen on the basic menu bar.

Terminal Type: When the router is connected to the DSLAM, select CPE. When the router is connect to a router for point to point application, one of the devices should be set to CO with the other set to CPE. The default setting is CPE.

Console Password: Disabled, a local user does not have to enter a password to enter the console mode. Enabled, users who attempt to access the device from the console will be prompted for the password.

Session Timeout: The console or telnet session will be terminated after this idle time. It is calculated in minutes. Users need to re-log on to the device when the session times out. The default setting is zero, which means the function is disabled.

26

July 2004

1740-A2-GB20-00

Image 26

Contents Shdsl July 1740-A2-GB20-00 July Table of Contents Chapter Application Example Appendix a Specifications Overview ApplicationLED Indicators Color Mode FunctionAC power adapter InstallationPreparing for Hardware Installation Four-wire 8P8C straight-through RJ45 cableDSL connection Power connectionRear-panel Connections Ethernet connectionQuick Installation LoginJuly Web Page Layout Monitoring the Shdsl Line WAN Interface Configuration Bridge Mode Service for One Fixed IP Address VCI1740-A2-GB20-00 July Router Mode Service for Five Static IP Addresses 1740-A2-GB20-00 July July 1740-A2-GB20-00 July PPPoE Shdsl 2/4-Wire Router User’s Guide PPPoA 1740-A2-GB20-00 July Password Setup Setting the Bridge Spanning Tree ProtocolStatic Bridging Write System Configurations Load Factory Default Values Setting up WAN and LAN Interfaces LAN InterfaceConfiguring the WAN Interface VC Data Flow Control Setting up an ISP Enable Snmp SnmpDisable Snmp Packet Filter Add a Packet Filter entryEnable/Disable Packet Filter Delete a Packet Filter entryAdd RoutingStatic Route ModifySet Up the RIP function 1740-A2-GB20-00 July Displaying the Routing Table NAT Multiple to One One to One NAT Multi-NAT 1740-A2-GB20-00 July Virtual Server Dhcp Dhcp ServerDhcp Relay DNS Proxy Igmp Click Apply to submit the settings Vlan Parameters and buttonsMaintenance and Diagnostics Software Upgrade and Configuration Backup /RestorationJuly 1740-A2-GB20-00 July OAM Loopback Ping Performance Monitoring 1740-A2-GB20-00 July Interface Application Example Adding the Static Route WebJuly Pin Assignments Line Port RJ45Console Port Cable Console AccessVT100 Compatible Terminal Keyboard Operations July Motoring the Shdsl Line Status Retrieve the Factory Default Settings Disable the Web BrowserSave the Configurations July Appendix a Specifications Environmental Conditions Power SupplyNetwork functions