Paradyne 1740 SHDSL manual PPPoA

Page 24

1740 SHDSL 2/4-Wire Router User’s Guide

3.2.4PPPoA

When a VC is configured for PPPoA, the router will auto-detect the Authentication code (PAP or CHAP), and the NAPT function will be enabled automatically.

STEP 1: Click WAN Setup on the Basic menu bar.

STEP 2: Enter values for the following fields: VPI, VCI, Encapsulation (LLC or VC MUX), Enable NAPT.

VPI	Enter a value for the vitual path identifier

VCI	Enter a value for the virtual channel identifier

LLC Encapsulation:	With LLC encapsulation, a link control header is added to the
	Ethernet packet that identifies the protocol type (Ethernet). This
	allows multiple protocols to be transmitted over the ATM Virtual
	Circuit.

VC Multiplexing:	With VC Multiplexing, no link control header is needed as the
	ATM Virtual Circuit is assumed to be carrying a single protocol.

Enable NAPT	Selecting Enabling NAPT will enable Network Port Address
	Translation on the WAN interface.

Keepalive Interval(sec):	Keep-alive is a networking operation that periodically checks
	the availability of a PPPoE/PPPoA connection between the CO
	and CPE. If the keep-alive message is not acknowledged, the
	connection will be interrupted.

STEP 3: Click PPPoA, and type the user name and password that the remote subscriber needs for Internet access.

STEP 4: Click on the Add button. The new VC is added in the Current ATM PVC List on the bottom screen.

24

July 2004

1740-A2-GB20-00

Image 24

Contents Shdsl July 1740-A2-GB20-00 July Table of Contents Chapter Application Example Appendix a Specifications Overview ApplicationLED Indicators Color Mode FunctionInstallation Preparing for Hardware InstallationAC power adapter Four-wire 8P8C straight-through RJ45 cablePower connection Rear-panel ConnectionsDSL connection Ethernet connectionQuick Installation LoginJuly Web Page Layout Monitoring the Shdsl Line WAN Interface Configuration Bridge Mode Service for One Fixed IP Address VCI1740-A2-GB20-00 July Router Mode Service for Five Static IP Addresses 1740-A2-GB20-00 July July 1740-A2-GB20-00 July PPPoE Shdsl 2/4-Wire Router User’s Guide PPPoA 1740-A2-GB20-00 July Password Setup Setting the Bridge Spanning Tree ProtocolStatic Bridging Write System Configurations Load Factory Default Values Setting up WAN and LAN Interfaces LAN InterfaceConfiguring the WAN Interface VC Data Flow Control Setting up an ISP Enable Snmp SnmpDisable Snmp Packet Filter Add a Packet Filter entryEnable/Disable Packet Filter Delete a Packet Filter entryRouting Static RouteAdd ModifySet Up the RIP function 1740-A2-GB20-00 July Displaying the Routing Table NAT Multiple to One One to One NAT Multi-NAT 1740-A2-GB20-00 July Virtual Server Dhcp Dhcp ServerDhcp Relay DNS Proxy Igmp Click Apply to submit the settings Vlan Parameters and buttonsMaintenance and Diagnostics Software Upgrade and Configuration Backup /RestorationJuly 1740-A2-GB20-00 July OAM Loopback Ping Performance Monitoring 1740-A2-GB20-00 July Interface Application Example Adding the Static Route WebJuly Pin Assignments Line Port RJ45Console Access VT100 Compatible TerminalConsole Port Cable Keyboard Operations July Motoring the Shdsl Line Status Retrieve the Factory Default Settings Disable the Web BrowserSave the Configurations July Appendix a Specifications Power Supply Network functionsEnvironmental Conditions