Paradyne 1740 SHDSL manual Virtual Server

Page 48

1740 SHDSL 2/4-Wire Router User’s Guide

8.4Virtual Server

If you want to set up Internet servers (such as an e-mail server, web server, or FTP server) on the virtual LAN when PAT is enabled, you should register the servers with the router first to allow Internet users to access the service via the WAN interface of router. This section describes how to configure a virtual server.

Click on NAPT on the Advanced menu bar to access the NAPT Configuration screen.

Global Port: The virtual server provides service for the Internet users via this port.

Protocol: TCP or UDP (default: TCP).

Private Address: This is the IP address of the Virtual Server

Private port: This is the port that the virtual server is connected to the Ethernet.

After configuring the parameters, click Add to add an entry.

To modify the parameters, select an item from the List of NAPT Entries. Modify the parameters, and click on the Modify button.

To delete the parameters, select an item from the List of NAPT Entries. Click on the Delete button.

48

July 2004

1740-A2-GB20-00

Image 48
Contents Shdsl July 1740-A2-GB20-00 July Table of Contents Chapter Application Example Appendix a Specifications Overview ApplicationLED Indicators Color Mode FunctionInstallation Preparing for Hardware InstallationAC power adapter Four-wire 8P8C straight-through RJ45 cablePower connection Rear-panel ConnectionsDSL connection Ethernet connectionQuick Installation LoginJuly Web Page Layout Monitoring the Shdsl Line WAN Interface Configuration Bridge Mode Service for One Fixed IP Address VCI1740-A2-GB20-00 July Router Mode Service for Five Static IP Addresses 1740-A2-GB20-00 July July 1740-A2-GB20-00 July PPPoE Shdsl 2/4-Wire Router User’s Guide PPPoA 1740-A2-GB20-00 July Password Setup Setting the Bridge Spanning Tree ProtocolStatic Bridging Write System Configurations Load Factory Default Values Setting up WAN and LAN Interfaces LAN InterfaceConfiguring the WAN Interface VC Data Flow Control Setting up an ISP Enable Snmp SnmpDisable Snmp Packet Filter Add a Packet Filter entryEnable/Disable Packet Filter Delete a Packet Filter entryRouting Static RouteAdd ModifySet Up the RIP function 1740-A2-GB20-00 July Displaying the Routing Table NAT Multiple to One One to One NAT Multi-NAT 1740-A2-GB20-00 July Virtual Server Dhcp Dhcp ServerDhcp Relay DNS Proxy Igmp Click Apply to submit the settings Vlan Parameters and buttonsMaintenance and Diagnostics Software Upgrade and Configuration Backup /RestorationJuly 1740-A2-GB20-00 July OAM Loopback Ping Performance Monitoring 1740-A2-GB20-00 July Interface Application Example Adding the Static Route WebJuly Pin Assignments Line Port RJ45Console Access VT100 Compatible TerminalConsole Port Cable Keyboard Operations July Motoring the Shdsl Line Status Retrieve the Factory Default Settings Disable the Web BrowserSave the Configurations July Appendix a Specifications Power Supply Network functionsEnvironmental Conditions