Paradyne 1740 SHDSL manual Console Access, VT100 Compatible Terminal, Console Port Cable

Page 66

1740 SHDSL 2/4-Wire Router User’s Guide

CHAPTER 16 Console Access

To access the device via the console port the following are required:

VT100 Compatible Terminal

This terminal is essential to perform the initial configuration of the router. This is normally a terminal with a VT100 emulation program, such as Telix or HyperTerminal Edition 5.

Console Port Cable

An RS-232, DB9-to-DB9 straight-through cable is only required if you need to connect the device to a VT100 terminal or equivalent. The cable is not supplied with the SHDSL router.

16.1.1Login

For access by console, the console PC should be installed with a standard VT100 emulation program, such as HyperTerminal 5 or Telix. You must connect the router to a PC using a serial cable. The following steps describe how to establish the console session.

STEP1: Run a standard VT100 program such as HyperTerminal (Ver. 5 is recommended), or Telix in the local terminal and select an open com port.

STEP2: Enter the following port settings:

Baud rate: 9600

Data bits: 8

Parity: none

Stop bit: 1

Flow control: none

STEP3: After the session parameters are set up, press the Enter Key. You will be requested to enter the user name and password.

STEP4: After successfully logging in, the main menu will appear.

66

July 2004

1740-A2-GB20-00

Image 66

Contents Shdsl July 1740-A2-GB20-00 July Table of Contents Chapter Application Example Appendix a Specifications Overview ApplicationLED Indicators Color Mode FunctionAC power adapter InstallationPreparing for Hardware Installation Four-wire 8P8C straight-through RJ45 cableDSL connection Power connectionRear-panel Connections Ethernet connectionQuick Installation LoginJuly Web Page Layout Monitoring the Shdsl Line WAN Interface Configuration Bridge Mode Service for One Fixed IP Address VCI1740-A2-GB20-00 July Router Mode Service for Five Static IP Addresses 1740-A2-GB20-00 July July 1740-A2-GB20-00 July PPPoE Shdsl 2/4-Wire Router User’s Guide PPPoA 1740-A2-GB20-00 July Password Setup Setting the Bridge Spanning Tree ProtocolStatic Bridging Write System Configurations Load Factory Default Values Setting up WAN and LAN Interfaces LAN InterfaceConfiguring the WAN Interface VC Data Flow Control Setting up an ISP Enable Snmp SnmpDisable Snmp Packet Filter Add a Packet Filter entryEnable/Disable Packet Filter Delete a Packet Filter entryAdd RoutingStatic Route ModifySet Up the RIP function 1740-A2-GB20-00 July Displaying the Routing Table NAT Multiple to One One to One NAT Multi-NAT 1740-A2-GB20-00 July Virtual Server Dhcp Dhcp ServerDhcp Relay DNS Proxy Igmp Click Apply to submit the settings Vlan Parameters and buttonsMaintenance and Diagnostics Software Upgrade and Configuration Backup /RestorationJuly 1740-A2-GB20-00 July OAM Loopback Ping Performance Monitoring 1740-A2-GB20-00 July Interface Application Example Adding the Static Route WebJuly Pin Assignments Line Port RJ45Console Access VT100 Compatible TerminalConsole Port Cable Keyboard Operations July Motoring the Shdsl Line Status Retrieve the Factory Default Settings Disable the Web BrowserSave the Configurations July Appendix a Specifications Power Supply Network functionsEnvironmental Conditions