Patton electronic 6511RC Temperature, Altitude, Humidity, Physical dimensions, LED Indicators

Model 6511RC User Manual 1 • Introduction

Temperature

Operating range: 32–104°F (0–40°C)

Altitude

Maximum operating altitude: 15,000 feet (4,752 meters)

Humidity

5 to 95% relative humidity (RH), non-condensing

Physical dimensions

•1.75 inches (4.44 cm) height, standard 19-inch (48.26 cm) width, 12-inch (30.48 cm) depth

•Weight: 1.55 lbs (0.70 kg)

LED Indicators

LED indicators on the front panel (see figure 5 on page 17) and rear panel (see figure 6 on page 18) display the status of Matrix Switch system resources. The front-panel LEDs are described in table 3. The rear-panel LEDs are described in table 4 on page 28.

			Table 3. Front-panel LED indicators
LED	Color	Status	Meaning
POWER	Green	On solid	Power is being applied.
		Flashing	The 6511RC has detected a power failure on a power bus.
		Off	No input power is being applied.
CPU FAIL	Red	On solid	CPU is unable to load the software from FLASH to RAM for operation.
		Off	The CPU is operating normally.
ALARM	Yellow	On solid	A minor alarm condition has been detected.
		Flashing	A major alarm condition has been detected.
		Off	The Model 6511RC system is operating normally.
SYSTEM	Green	Flashing	The Model 6511RC system is operating normally.
		Off	The Model 6511RCsystem is not functioning properly.
ENET(NODE)	Green	On solid	Indicates there is Ethernet frame activity on one or more of the 6511RC’s Ethernet inter-
			faces, including the two rear-panel 10/100/1000 ports, the front -panel 10/100 port,
			and the packet--switched PICMG 2.16 bus.
		Off	Indicates NO Ethernet frame activity detected on any of the 6511RC’s Ethernet interfaces,
			including the PICMG 2.16 bus.
CLK SOURCE	Green	On solid	The 6511RC is defined as the Primary (master) clock source for the H.100 bus
		Flashing	The 6511RC is defined as the Secondary (alternate master) clock source.
		Off	The 6511RC is defined as a slave, deriving its clock from the H.110 Bus.
CLK ERROR	Yellow	On solid	Primary Master Clock source has been lost and the 6511RC is using the secondary
			source for its clock.
		Flashing	Master Clock source and the Secondary Clock source have been lost and the 6511RC
			is using its internal crystal for its clock.
		Off	No clock errors currently detected.

Hardware overview 27