Patton electronic user manual Using a browser to complete Model 6511RC configuration

Model 6511RC User Manual 3 • Configuring the Matrix Switch for operation

19.Press the left-arrow cursor key until the TOP LEVEL MANAGEMENT window displays.

20.Select a for Home, then press <Enter>.

21.Under the Current Status page, type 1 (store Config(1)) to save the changes you have just made to the con- figuration.

This completes the initial configuration of the Model 6511RC. The next steps in configuration will be done using your web browser connected via Ethernet to the 6511RC.

Using a browser to complete Model 6511RC configuration

This section describes the following procedures:

•Displaying the Matrix Switch home page (see section “Displaying the Matrix Switch 6511RC web adminis- tration pages” on page 47)

•Defining the IP default gateway (see section “Configuring the default gateway” on page 51)

•Defining the system clocking parameters (see section “Configuring the system clocking parameters” on page 52)

•Defining the STM-1 Circuit parameters (see section “Configuring the SDH circuit parameters” on page 54)

•Enabling idle code generation for designated DS0 channels (see section “Configuring DS0 idle codes” on page 58)

•Defining DS0 mappings within the STM-1 link (see section “Selecting the SDH mapping path” on page 60)

Displaying the Matrix Switch 6511RC web administration pages Do the following:

1.Connect your PC’s Ethernet connection to the Ethernet LAN.

2.Connect the 6511RC’s Matrix Switch 10/100 Ethernet port to the Ethernet LAN.

3.At your PC, open a web browser session. In your browser’s URL/address field type the IP address of the Model 6511RC (for example, if the Model 6511RC’s IP address 123.124.221.10, you would type 123.124.221.10 in the browser’s URL/address field). If you do not have an IP address in your TDAC, refer to “Initial configuration through the RS-232 control port” on page 43.

4.A login prompt will appear. In the username field type superuser then press <Tab> to move the cursor to the Password field. In the password field type superuser then press <Enter>.

Using a browser to complete Model 6511RC configuration 47