Patton electronic 5400 manual Console, Connecting a serial terminal

Page 52

SmartNode 5400 Getting Started Guide

C • Cabling

 

 

Introduction

This section provides information on the cables used to connect the SmartNode and the interface cards to the existing network infrastructure and to third party products.

Console

The SmartNode can be connected to a serial terminal over its serial console port, as depicted in figure 9.

The interconnecting cables shall be acceptable for external use

and shall be rated for the proper application with respect to volt-

age, current, anticipated temperature, flammability, and

CAUTION mechanical serviceability.

+

12V, 1.25A

ACT

LINK

ET

T

Reset

C

 

onsole

 

RS-

 

232

Serial Terminal

Note A Patton Model 16F-561 RJ45 to DB-9 adapter is included with each SmartNode 5400 Series device

Figure 9. Connecting a serial terminal

Note See section “Console port” on page 55 for console port pin-outs.

Introduction

52

Image 52
Contents SmartNode 5400 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Shdsl Basic Configuration Cabling List of Figures List of Tables Audience About this guideStructure Precautions Impaired functioningSafety when working with electricity General observations General conventions Typographical conventions used in this documentConvention Meaning Chapter contents General informationSmartNode 5400 overview SN5400 model codesSmartNode 5400 rear panel SmartNode 5400 rear panel ports are described in tableWAN ETH 0/0 SmartNode 5400 front panel SN5400LED DescriptionApplications overview Introduction Typical applicationSmartNode installation Planning the installation Network DiagramSite log Network informationInstalling the gateway router Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables Internal AC Power Supply Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCConfiguring the desired IP address Factory-default IP settingsLogin Changing the WAN IP addressConnecting the SmartNode to the network LANLoading the configuration optional Bootloader Start BootloaderStart-up with factory configuration Step Command PurposeStep Command Purpose Load a new application image SmartWare via the serial link Xmodem ymodem -bAdditional information Shdsl Basic Configuration Line Setup Configuring PPPoEConfiguration Summary Setting up permanent virtual circuits PVC Using PVC channels in bridged Ethernet modeUsing PVC channels with PPPoE Command PurposeTroubleshooting DSL Connections DiagnosticsContacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Low-Voltage Directive Safety ComplianceCE Declaration of Conformity Authorized European RepresentativeAppendix B Specifications Voice processing signalling dependent Voice signallingData connectivity Fax and modem supportIP services ManagementSystem PhysicalShdsl Daughter Card if applicable Factor SpecsIdentification of the SmartNode devices via Snmp SmartNode Model SysObjectIDAppendix C Cabling Connecting a serial terminal ConsoleEthernet Appendix D Port pin-outs Pin Signal Console portShdsl port Appendix E SmartNode 5400 factory configuration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses