ZyXEL Communications AES-100 manual Dimensions

Page 17

AES-100 User’s Guide

∙Each network module has eight RJ-11 ports to the CO side and eight RJ-11 ports to the USER side

∙Each network module has one 10 M Ethernet port

∙Each network module has one RS-232 console port for local configuration and management

Dimensions

∙In mm: 440 (W) x 320 (L) x 66 (H)

Weight

∙6.84 kg (two network modules loaded)

Power Consumption

∙80 watts maximum

∙100 - 240 VAC, 50/60 Hz

Operating Environment

∙Temperature: 0 - 50°C; Humidity: 20% - 95%

Storage Environment

∙Temperature: -30 - 60°C; Humidity: 20% - 95%

Getting to Know the AES-100

1-5

Image 17

Contents AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Chapter Getting to Know the AES-100 FeaturesProtocol MTU Application BenefitsISP Application Physical SpecificationsCompact Design for Limited Space Scalable Platform for Future ExpansionDimensions Page Chapter Hardware Overview Additional Installation RequirementsUnpacking the AES-100 Front PanelFront Panel LEDs Console PortFront Panel Ports Rear Panel Adsl Port ConnectionsConnecting the Power Cord to the AES-100 and a Power Source Console Connection Chapter Software ConfigurationCommand Line Interface System Commands Command StructureUptime Command Version CommandPasswd Command Restart CommandConfig Print Command Config Save CommandPage Configured Vs. Actual Speed Chapter Adsl ConfigurationDefault Settings Adsl StandardsDisable Ports Command Adsl CommandsDisable Port Command Linedata Command Enable Port CommandEnable Ports Command Lineinfo Command Lineperf Command List Port Command Linerate CommandSet Ports Command List Ports CommandSet Port Command Show Ports Command Show Port CommandEthernet Commands Mbps Ethernet Port ConfigurationSet Duplex Command Status CommandMbps Ethernet Port Configuration Default Settings of Port-Based Vlan Chapter Bridge ConfigurationBridge Port Numbers Port-Based VlanDevice Command Bridge CommandsFilter Command Filterage CommandFlush Command Port-Based Vlan CommandsInfo Command Portfilter CommandBridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Setting the IP Address Chapter IP ConfigurationConfig Command General IP CommandsStatistics Command Ping CommandPage Snmp Management Chapter Remote ManagementManagement by Telnet Supported MIBs Snmp Access ConfigurationSnmp Access Read/Write Command Snmp Access Delete command Snmp Trap ConfigurationSnmp Access Flush Command Snmp Access List CommandAES-100 User’s Guide Trap Delete Command Trap Add CommandTrap Flush Command Trap List CommandPage Control Files Used In Tftp Operation Chapter Configuration Backup/RestoreConfiguration Files of the AES-100 Configuration Restore Configuration BackupProcess, used only in restoration Page Chapter Firmware Upload BOOTP/TFTP Firmware Update of the AES-100BOOTP/TFTP Server Input MAC Database Edit Dialog Transfer control files and firmware file to the AES-100 Tftp Firmware Update on the AES-100Page Data Transmission Chapter TroubleshootingAdsl LEDs Data Rate Configured SettingsAdsl LEDs turn On and Off Snmp PasswordRemote Server Telnet Troubleshooting TelnetIndex Rear Panel Connections Terminal Emulation