3.4.3Restart Command
Syntax:
restart
The restart command instructs the system to perform a warm start, i.e., restarting the system without turning the power on and off.
It is very important that you remember your password. If you forget it, refer to the Troubleshooting section
for help.
3.4.4Passwd Command
Syntax:
passwd
The passwd command changes the management password. The management password is used for authentication at console or telnet login. This command is only allowed for local console management sessions. The management password must be from 1 to 8 characters long and any character is accepted. The factory default password is “1234”.
3.4.5Config Print Command
Syntax:
config print
The config print command lists all current system configuration settings.
3.4.6Config Save Command
Syntax:
config save
The config save command saves all system configurations into nonvolatile memory. You must use this command to save any configurations that you make, otherwise the
3.4.7Exit Command
Syntax:
exit
The exit command terminates the console or telnet mana gement session.
Software Configuration |