ZyXEL Communications AES-100 manual Ping Command, Statistics Command

Page 45

AES-100 User’s Guide

7.2.2Ping Command

Syntax:

ping <host> [<ttl> [<size>]]

This is an IP facility to check for network functionality by sending an echo request to another IP host and waiting for the reply. The host parameter specifies the IP address of the target. The optional ttl (time to live) limits the number of hops (routers) that the echo request can travel before it reaches the target. The size parameter specifies the size of the payload, i.e., not counting the headers, of the echo request; the default size is 32 octets.

7.2.3Statistics Command

Syntax:

stats <sub cmd>

This command shows the statistics for the traffic of the type specified by the sub-command. Statistics are available for the following traffic types: ARP, ICMP, IP, raw, TCP and UDP.

7.2.4Version Command

Syntax:

version

This command shows the software number of the IP implementation.

IP Configuration

7-3

Image 45

Contents AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Chapter Getting to Know the AES-100 FeaturesProtocol MTU Application BenefitsISP Application Physical SpecificationsCompact Design for Limited Space Scalable Platform for Future ExpansionDimensions Page Chapter Hardware Overview Additional Installation RequirementsUnpacking the AES-100 Front PanelConsole Port Front Panel PortsFront Panel LEDs Rear Panel Adsl Port ConnectionsConnecting the Power Cord to the AES-100 and a Power Source Chapter Software Configuration Command Line InterfaceConsole Connection System Commands Command StructureUptime Command Version CommandPasswd Command Restart CommandConfig Print Command Config Save CommandPage Configured Vs. Actual Speed Chapter Adsl ConfigurationDefault Settings Adsl StandardsAdsl Commands Disable Port CommandDisable Ports Command Enable Port Command Enable Ports CommandLinedata Command Lineinfo Command Lineperf Command List Port Command Linerate CommandList Ports Command Set Port CommandSet Ports Command Show Ports Command Show Port CommandEthernet Commands Mbps Ethernet Port ConfigurationSet Duplex Command Status CommandMbps Ethernet Port Configuration Default Settings of Port-Based Vlan Chapter Bridge ConfigurationBridge Port Numbers Port-Based VlanDevice Command Bridge CommandsFilter Command Filterage CommandFlush Command Port-Based Vlan CommandsInfo Command Portfilter CommandBridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Setting the IP Address Chapter IP ConfigurationConfig Command General IP CommandsStatistics Command Ping CommandPage Chapter Remote Management Management by TelnetSnmp Management Snmp Access Configuration Snmp Access Read/Write CommandSupported MIBs Snmp Access Delete command Snmp Trap ConfigurationSnmp Access Flush Command Snmp Access List CommandAES-100 User’s Guide Trap Delete Command Trap Add CommandTrap Flush Command Trap List CommandPage Chapter Configuration Backup/Restore Configuration Files of the AES-100Control Files Used In Tftp Operation Configuration Restore Configuration BackupProcess, used only in restoration Page Chapter Firmware Upload BOOTP/TFTP Firmware Update of the AES-100BOOTP/TFTP Server Input MAC Database Edit Dialog Transfer control files and firmware file to the AES-100 Tftp Firmware Update on the AES-100Page Chapter Troubleshooting Adsl LEDsData Transmission Configured Settings Adsl LEDs turn On and OffData Rate Password Remote ServerSnmp Telnet Troubleshooting TelnetIndex Rear Panel Connections Terminal Emulation