ZyXEL Communications AES-100 Bridge Commands, Device Command, Filter Command, Filterage Command

Page 38

AES-100 User’s Guide

-Bridge port 9 (ADSL port 8) allowed to bridge port 1 (Ethernet port) only

It is recommended that you do not alter these settings, or the AES-100 may not work correctly.

The default VLAN settings allow each ADSL port to communicate back and forth with only the Ethernet port, and not with other ADSL ports. The following figure illustrates this.

Figure 6-1 Default VLAN Settings

6.3Bridge Commands

6.3.1Device Command

Syntax:

device

The device command shows information on all bridge ports.

6.3.2Filter Command

Syntax:

filter

The filter command displays the filtering database.

6.3.3Filterage Command

Syntax:

filterage [age]

where

age = aging out timer period in seconds

6-2	Bridge Configuration

Image 38

Contents AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Features Chapter Getting to Know the AES-100Protocol Benefits MTU ApplicationCompact Design for Limited Space Physical SpecificationsISP Application Scalable Platform for Future ExpansionDimensions Page Unpacking the AES-100 Additional Installation RequirementsChapter Hardware Overview Front PanelFront Panel LEDs Console PortFront Panel Ports Adsl Port Connections Rear PanelConnecting the Power Cord to the AES-100 and a Power Source Console Connection Chapter Software ConfigurationCommand Line Interface Uptime Command Command StructureSystem Commands Version CommandConfig Print Command Restart CommandPasswd Command Config Save CommandPage Default Settings Chapter Adsl ConfigurationConfigured Vs. Actual Speed Adsl StandardsDisable Ports Command Adsl CommandsDisable Port Command Linedata Command Enable Port CommandEnable Ports Command Lineinfo Command Lineperf Command Linerate Command List Port CommandSet Ports Command List Ports CommandSet Port Command Show Port Command Show Ports CommandSet Duplex Command Mbps Ethernet Port ConfigurationEthernet Commands Status CommandMbps Ethernet Port Configuration Bridge Port Numbers Chapter Bridge ConfigurationDefault Settings of Port-Based Vlan Port-Based VlanFilter Command Bridge CommandsDevice Command Filterage CommandInfo Command Port-Based Vlan CommandsFlush Command Portfilter CommandBridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Chapter IP Configuration Setting the IP AddressGeneral IP Commands Config CommandPing Command Statistics CommandPage Snmp Management Chapter Remote ManagementManagement by Telnet Supported MIBs Snmp Access ConfigurationSnmp Access Read/Write Command Snmp Access Flush Command Snmp Trap ConfigurationSnmp Access Delete command Snmp Access List CommandAES-100 User’s Guide Trap Flush Command Trap Add CommandTrap Delete Command Trap List CommandPage Control Files Used In Tftp Operation Chapter Configuration Backup/RestoreConfiguration Files of the AES-100 Configuration Backup Configuration RestoreProcess, used only in restoration Page BOOTP/TFTP Firmware Update of the AES-100 Chapter Firmware UploadBOOTP/TFTP Server Input MAC Database Edit Dialog Tftp Firmware Update on the AES-100 Transfer control files and firmware file to the AES-100Page Data Transmission Chapter TroubleshootingAdsl LEDs Data Rate Configured SettingsAdsl LEDs turn On and Off Snmp PasswordRemote Server Troubleshooting Telnet TelnetIndex Rear Panel Connections Terminal Emulation