ZyXEL Communications AES-100 manual Port-Based Vlan Commands, Flush Command, Info Command

Page 39

AES-100 User’s Guide

The filterage command sets or shows the aging out timer period of the filtering database. It is recommended that you use the default setting. If the time interval is reduced to a setting that is too short, it could increase broadcast traffic and reduce the available bandwidth.

6.3.4Flush Command

Syntax:

flush [port]

where

[port] = bridge port number, from 1 to 9

The flush command flushes out the filtering database of the specified bridge port. If the <port> field is omitted, this command will flush out the filtering databases of all ports.

6.3.5Info Command

Syntax:

info

The info command shows the software number of the bridge implementation and the maximum size of the filtering database.

6.3.6Status Command

Syntax:

status

The status command displays the bridge status.

6.4Port-Based VLAN Commands

6.4.1Portfilter Command

Syntax:

portfilter [<source port> all<dest ports>]

where

<source port> = incoming bridge port number, from 1 to 9 all = all bridge ports are allowed outgoing ports

<dest ports> = the allowed outgoing bridge port number, separate by a space if there is more than one port

Bridge Configuration

6-3

Image 39
Contents AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Chapter Getting to Know the AES-100 FeaturesProtocol MTU Application BenefitsScalable Platform for Future Expansion Physical SpecificationsISP Application Compact Design for Limited SpaceDimensions Page Front Panel Additional Installation RequirementsChapter Hardware Overview Unpacking the AES-100Console Port Front Panel PortsFront Panel LEDs Rear Panel Adsl Port ConnectionsConnecting the Power Cord to the AES-100 and a Power Source Chapter Software Configuration Command Line InterfaceConsole Connection Version Command Command StructureSystem Commands Uptime CommandConfig Save Command Restart CommandPasswd Command Config Print CommandPage Adsl Standards Chapter Adsl ConfigurationConfigured Vs. Actual Speed Default SettingsAdsl Commands Disable Port CommandDisable Ports Command Enable Port Command Enable Ports CommandLinedata Command Lineinfo Command Lineperf Command List Port Command Linerate CommandList Ports Command Set Port CommandSet Ports Command Show Ports Command Show Port CommandStatus Command Mbps Ethernet Port ConfigurationEthernet Commands Set Duplex CommandMbps Ethernet Port Configuration Port-Based Vlan Chapter Bridge ConfigurationDefault Settings of Port-Based Vlan Bridge Port NumbersFilterage Command Bridge CommandsDevice Command Filter CommandPortfilter Command Port-Based Vlan CommandsFlush Command Info CommandBridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Setting the IP Address Chapter IP ConfigurationConfig Command General IP CommandsStatistics Command Ping CommandPage Chapter Remote Management Management by TelnetSnmp Management Snmp Access Configuration Snmp Access Read/Write CommandSupported MIBs Snmp Access List Command Snmp Trap ConfigurationSnmp Access Delete command Snmp Access Flush CommandAES-100 User’s Guide Trap List Command Trap Add CommandTrap Delete Command Trap Flush CommandPage Chapter Configuration Backup/Restore Configuration Files of the AES-100Control Files Used In Tftp Operation Configuration Restore Configuration BackupProcess, used only in restoration Page Chapter Firmware Upload BOOTP/TFTP Firmware Update of the AES-100BOOTP/TFTP Server Input MAC Database Edit Dialog Transfer control files and firmware file to the AES-100 Tftp Firmware Update on the AES-100Page Chapter Troubleshooting Adsl LEDsData Transmission Configured Settings Adsl LEDs turn On and OffData Rate Password Remote ServerSnmp Telnet Troubleshooting TelnetIndex Rear Panel Connections Terminal Emulation