ZyXEL Communications AES-100 manual Chapter Adsl Configuration, Adsl Standards, Default Settings

Page 27

AES-100 User’s Guide

Chapter 4

ADSL Configuration

The ADSL (Asymmetrical Digital Subscriber Line) subsystem allows you to configure and monitor the ADSL ports.

4.1ADSL Standards

The AES-100 supports both the G.lite and the G.dmt standards. G.lite is intended to minimize the cost for the consumer market.

Table 4-1 ADSL Standards

STANDARD

MAXIMUM DOWNSTREAM

MAXIMUM UPSTREAM

 

 

 

G.dmt

8160 Kbps

1024 Kbps

 

 

 

G.lite

1536 Kbps

512 Kbps

 

 

 

4.2Configured Vs. Actual Speed

You configure the maximum speed of the individual ADSL port using the set port command. However, due to noise and other factors on the line, the actual speed may not reach the maximum that you specify.

Even though you can specify arbitrary numbers in the set port command, the actual speed is always a multiple of 32 Kbps. If you enter a speed that is not a multiple of 32 Kbps, the actual speed will be the next lower multiple of 32Kbps. For instance, if you specify 60 Kbps for a port, the actual speed for that port will not exceed 32 Kbps, and if you specify 66 Kbps, the actual speed will not be over 64Kbps.

Note that when you configure an ADSL port, the upstream speed must be less than or equal to the downstream speed. Note also that the list port command displays the configured parameters of the ADSL port, while the show port command displays the actual speeds.

4.3Default Settings

The factory default settings for all ADSL ports of the AES -100 are

-Encapsulation: RFC 1483

-Multiplexing: LLC-based

-VPI : 0

-VCI : 33

ADSL Configuration

4-1

Image 27
Contents AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Chapter Getting to Know the AES-100 FeaturesProtocol MTU Application BenefitsScalable Platform for Future Expansion Physical SpecificationsISP Application Compact Design for Limited SpaceDimensions Page Front Panel Additional Installation RequirementsChapter Hardware Overview Unpacking the AES-100Console Port Front Panel PortsFront Panel LEDs Rear Panel Adsl Port ConnectionsConnecting the Power Cord to the AES-100 and a Power Source Chapter Software Configuration Command Line InterfaceConsole Connection Version Command Command StructureSystem Commands Uptime CommandConfig Save Command Restart CommandPasswd Command Config Print CommandPage Adsl Standards Chapter Adsl ConfigurationConfigured Vs. Actual Speed Default SettingsAdsl Commands Disable Port CommandDisable Ports Command Enable Port Command Enable Ports CommandLinedata Command Lineinfo Command Lineperf Command List Port Command Linerate CommandList Ports Command Set Port CommandSet Ports Command Show Ports Command Show Port CommandStatus Command Mbps Ethernet Port ConfigurationEthernet Commands Set Duplex CommandMbps Ethernet Port Configuration Port-Based Vlan Chapter Bridge ConfigurationDefault Settings of Port-Based Vlan Bridge Port NumbersFilterage Command Bridge CommandsDevice Command Filter CommandPortfilter Command Port-Based Vlan CommandsFlush Command Info CommandBridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Setting the IP Address Chapter IP ConfigurationConfig Command General IP CommandsStatistics Command Ping CommandPage Chapter Remote Management Management by TelnetSnmp Management Snmp Access Configuration Snmp Access Read/Write CommandSupported MIBs Snmp Access List Command Snmp Trap ConfigurationSnmp Access Delete command Snmp Access Flush CommandAES-100 User’s Guide Trap List Command Trap Add CommandTrap Delete Command Trap Flush CommandPage Chapter Configuration Backup/Restore Configuration Files of the AES-100Control Files Used In Tftp Operation Configuration Restore Configuration BackupProcess, used only in restoration Page Chapter Firmware Upload BOOTP/TFTP Firmware Update of the AES-100BOOTP/TFTP Server Input MAC Database Edit Dialog Transfer control files and firmware file to the AES-100 Tftp Firmware Update on the AES-100Page Chapter Troubleshooting Adsl LEDsData Transmission Configured Settings Adsl LEDs turn On and OffData Rate Password Remote ServerSnmp Telnet Troubleshooting TelnetIndex Rear Panel Connections Terminal Emulation