Peavey CS 800H manual To Stereo

9 5 2 3 4 7 1 8 6

10

11

	Bi-Amp Operation (sub woofer & mid/high enclosure)
	Set AMP MODE switch		to STEREO.
1.		1
	Set the A channel AMP FUNCTION switch				to LOW PASS.
2.				2

3.Turn on the A channel LOW CUT SWTICH 3 .

4.	Set channel A LOW CUT frequency adjustment knob	4	to match the low frequency cut-off or the -3 dB down point
	of the sub woofer. (If you don’t know this specification‚ set it for 40 Hz.)

5.Set the channel A CROSSOVER frequency adjustment knob 100–150 Hz).

5

to the desired crossover frequency (usually

6.	Set the channel B AMP FUNCTION switch	6	to FULL RANGE.
7.	Plug a short shielded cable into the Channel A Low Pass output					.
				7
8.	Connect the other end of the same cable to the channel B input			8	.

9.Connect the Mono program signal to the channel A input 9 .

10. Connect the sub woofer(s) (in parallel) to the channel A output 10 .

11.Connect the mid/high enclosure(s) (in parallel) to the channel B output

11.

15