Peavey CS 800H manual Setup-Anweisungen

Setup-Anweisungen

Stereo Operation

1. Set AMP MODE switch 1 to STEREO.

2.Set the A and B channel AMP FUNCTION switches

2

and

3

to FULL RANGE.

3.Connect the Left and Right program signal to the A and B channel inputs:

4

and

5

.

4.Connect the A and B channel speaker outputs

7

and

8

to the loudspeaker full range inputs.

4

2

6

1

5

3

7

9

8

Bridge Mode Operation

1.Set AMP MODE switch

1

to BRIDGE.

2.	Connect the program signal to the A channel input	4	.
3.	Connect the loudspeaker across the two RED binding posts on the amplifier outputs			9	. The A channel is positive
	and the B channel is negative or between th 1+ and 2+ pins of the A channel Speakon				connector	7	(the 1+ positive
	and the 2+ pin is negative).
	Two Channel Parallel Operation (Full Range)

1.Set AMP MODE switch

1

to STEREO.

2.Set the A and B channel AMP FUNCTION switches

2

and

3

to Full Range .

3.Connect the program signal to the A channel input 4 .

4.Plug a short shielded cable into the A HIGH PASS/FULL RANGE output

6.

5.Connect the other end of the same cable to the B channel input

5

.

6.Connect the A and B channel speaker outputs

7

and

8

. to the loudspeaker full range inputs.

54