Peavey CS 800H manual Important Safety Instructions, Sound Level dBA, Slow Response

Page 3

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electrical products, basic cautions should always be followed, including the following:

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11.Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug‚ proceed as follows:

a)The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E‚ the earth symbol‚ colored green or colored green and yellow.

b)The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black.

c)The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red.

12.Only use attachments/accessories provided by the manufacturer.

13.Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a

cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

14.Unplug this apparatus during lightning storms or when unused for long periods of time.

15.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

16.Never break off the ground pin. Write for our free booklet “Shock Hazard and Grounding.” Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

17.If this product is to be mounted in an equipment rack, rear support should be provided.

18.Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in suscep- tibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures:

Duration Per Day In Hours

Sound Level dBA, Slow Response

8

90

6

92

4

95

3

97

2

100

1 12

102

1

105

12

110

14 or less

115

According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation.

SAVE THESE INSTRUCTIONS!

3

Image 3
Contents CS800H Operations Manual Page Sound Level dBA, Slow Response Important Safety InstructionsCooling Requirements CS 800H Power AmplifierUnpacking MountingR E U G E A R T Operating PrecautionsStereo Connecting InputsConnecting Outputs Connecting PowerInput Attenuators AC Power Switch/Circuit BreakerFront Panel Indicators Signal LEDAir Intake Vent Mode Select SwitchDDT Switch Active LEDLow Cut Adjustment Knob Crossover Adjustment KnobAmp Function Switch Low Cut SwitchDDT RampUp Signal Control Amplifier Maintenance and User ResponsibilitySpeaker Protection Diagram Glossary of Terms Setup Instructions To Stereo Bi-amp Hookup Diagram CS 800H CS 800H Verstärker AuspackenMontage Sicherheitshinweise für den Betrieb KühlanforderungenAnschluss der Ausgänge Anschluss der EingängeBridged-Modus NetzanschlussTEMP-LED SIGNAL-LEDACTIVE-LED Low-Cut-Schalter KanaleingangFrequenzweichen-Einstellknopf Amp-Function-SchalterErmittlung und Begrenzung von Verzerrung DDT Speakon-AusgangssteckerAnschlussklemmen-Ausgangsstecker Stecker des WechselstromnetzkabelsEinschalt-/Ausschaltschutz RampUp-SignalregelungKurzschluss Schutz vor GleichspannungWartung des Verstärkers und Verantwortung des Nutzers Erklärung der Begriffe Setup-Anweisungen Mono-Biamp-Betrieb Subwoofer und Mid/High-Box CS 800H Amplificador de Poder CS 800H DesempaqueInstalación Precauciones de Operación Requisitos de enfriamientoConectando Salidas Conectando EntradasMono Puente Conectando CorrienteEstéreo ParaleloLED de Señal Interruptor de Corriente/Breaker de CircuitoAtenuadores de Entrada Indicadores del Panel FrontalLED Activo Interruptor de Función del Amplificador Interruptor DDTEntrada de Canal Perilla de ajuste del CrossoverConectador e corriente CA Salida de LOW PassConectador de salida Speakon Conectores de salida de poste binding postCortos Circuitos Limitación de Detección de DistorsiónSensibilidad de Impedancia LFC Protección TérmicaProtección de Encendido/Apagado Control de señal RampUpProtección de Parlantes Glosario de Términos Operación de Dos Canales Paralelos Rango Completo Operación Mono Bi-Amp CS 800H Refroidissement InstallationAmplificateurs de Puissance CS 800H DéballagePrécautions d’Utilisation Stéréo Connecter les entrées de votre unité InputsConnecter les sorties de votre unité Outputs Alimentation ElectriqueIndicateurs du Panneau Avant Signal LEDTemp LED DDT LEDActive LED Limite de Détection de Distortion Protection ThermiqueProtection contre le Courant Continu Protection des Haut-Parleurs Maintenance et Responsabilité d’UtilisateurProtection de Mise Sous/Hors Tension Système RampUp contrôle de montée en puissanceGlossaire Setup-Anweisungen To Stereo CS 800H Page Page Product Category Peavey Electronics Corporation Limited Warranty80304955