Kramer Electronics PL-150 Controlling via the Embedded Web Pages, Following window appears

Page 17

Connecting the PL-50 Power Controller - Monitor

6.3 Controlling via the Embedded Web Pages

The embedded Web page can be used to remotely operate the PL-50via the Ethernet (see section 6.2).

6.3.1Setting the Embedded Web Page

Before you use the embedded Web pages to control the PL-50via the Ethernet, check that the Java™ software is installed on your computer. If not, download it from: www.java.com.

A description of each Web page appears if you hover with your mouse over the

question mark that appears on the left side of the screen.

To control the PL-50via the embedded Web page, make sure that it is connected to the Ethernet port of your computer and do the following:

1.Open your Internet browser.

2.Type the unit’s IP number1 in the address bar of your browser (or the name, if using DHCP):

Figure 11: Typing the IP Number

The following window appears:

Figure 12: Loading the Embedded Web Pages

1 The default IP number is 192.168.1.39, and may be changed by the system integrator

13

Image 17

Contents Model Contents Instruction Codes43 FiguresTables Getting Started IntroductionP3K Wizard Software Quick StartGetting Started Ethernet OverviewYour PL-50 Power Controller Monitor Your PL-50 Power Controller MonitorPL-50 Power Controller Monitor Front Panel Feature Function PL-50 Power Controller Monitor FeaturesBefore Installing in a Rack Installing in a RackConnecting the PL-50 Connecting the PL-50 Power Controller MonitorControlling the PL-50 via the Ethernet Port Connecting the RelaysRight-click Local Area Connection Properties Local Area Connection Properties window appearsConnecting via a Straight-Through Cable Upload Main Screen Click the Connect button Connect screen appears as followsIf required, make changes and click Save. If not, click Exit Following window appears Controlling via the Embedded Web PagesRunning the Application Panel Screen Scheduler Screen Scheduler Screen FeaturesHelp BOX Channel Settings Screen Features Define the Channel Settings screenDefine the Alerts screen Alerts Screen FeaturesSetting the Alarms Power Measurement Screen Features Define the Power Measurement screenPower ON/OFF Order Screen This page lets you set the power on and OFF order and delay Configurations Screen Security System Enabled Enable Security SystemSecurity System DIP-switch Settings Operating Your PL-50 Power Controller MonitorDIP-switch Definitions Calibrating via the Front Panel ButtonsOperating Your PL-50 Power Controller Monitor Upgrading the Firmware Flash Memory UpgradeUpload Screen Click the Connect button Connect Window appears see FigureConnection Time Out Message Machine is now connectedUpload Connected Upload Progress Restart Message When the update is finished, the restart message appearsIncludes the technical specifications Technical SpecificationsTechnical Specifications1 of the PL-50 Changing the Device ParametersProtocol 3000 Syntax Kramer ProtocolHost message format CR LFCommand Command TermsCommon Commands Name FactoryNAME? NAME? NameSecurity Commands Result and Error CodesThese commands are used by network devices running Protocol Network Setting CommandsNET-DHCP? NET-DHCPNET-GATE NET-GATE?Instruction Codes ALARM-ON ALARM-OFFALARM-ON Result ALARM-ON? ALARM-START-ASMES-MODE SwitchLVL SCHED?SWITCH-ORDER SWITCH?SWITCH-ORDER-DELAY SWITCH-ORDER-DELAY?Limited Warranty 2900-000576 REV