Kramer Electronics PL-150 user manual Technical Specifications, Changing the Device Parameters

Page 39

Technical Specifications

8.2Changing the Device Parameters

To change the device parameters do the following:

1.Connect a PC to the PL-50(see section 8.1.2).

2.Open K-UPLOAD (see Figure 30).

3.Click the Connect button to open the Connect window (see Figure 31).

4.Choose the appropriate type of connection: Ethernet, Serial or USB, and click Connect.

The Connect window disappears and the Device Properties become visible.

5.Change the parameters as required and then click Save.

9Technical Specifications

Table 10 includes the technical specifications:

Table 10: Technical Specifications1 of the PL-50

INPUT POWER SOURCE:

For Europe: 230V AC, 50/60Hz, 10VA, internal

For the USA 130V AC, 130V AC, 50/60Hz, 10VA, internal

OUTPUTS:	For Europe: 5 x 220-240V AC outputs, total load of 10A Max.
	For the USA: 5 x 100-120V AC outputs, total load of 10A Max.
DIMENSIONS:	19-inch (W), 7-inch (D) 1U (H) rack-mountable
WEIGHT:	2.7kg (6lbs) approx.
ACCESSORIES:	Power cord, Windows®-based Kramer control software,
	Infrared remote control transmitter

1 Specifications are subject to change without notice

35

Image 39

Contents Model Contents Instruction Codes43 FiguresTables Quick Start IntroductionGetting Started P3K Wizard SoftwareGetting Started Ethernet OverviewYour PL-50 Power Controller Monitor Your PL-50 Power Controller MonitorPL-50 Power Controller Monitor Front Panel Feature Function PL-50 Power Controller Monitor FeaturesBefore Installing in a Rack Installing in a RackConnecting the PL-50 Connecting the PL-50 Power Controller MonitorLocal Area Connection Properties window appears Connecting the RelaysControlling the PL-50 via the Ethernet Port Right-click Local Area Connection PropertiesConnecting via a Straight-Through Cable Upload Main Screen Click the Connect button Connect screen appears as followsIf required, make changes and click Save. If not, click Exit Following window appears Controlling via the Embedded Web PagesRunning the Application Panel Screen Scheduler Screen Scheduler Screen FeaturesHelp BOX Channel Settings Screen Features Define the Channel Settings screenDefine the Alerts screen Alerts Screen FeaturesSetting the Alarms Power Measurement Screen Features Define the Power Measurement screenPower ON/OFF Order Screen This page lets you set the power on and OFF order and delay Configurations Screen Security System Enabled Enable Security SystemSecurity System Calibrating via the Front Panel Buttons Operating Your PL-50 Power Controller MonitorDIP-switch Settings DIP-switch DefinitionsOperating Your PL-50 Power Controller Monitor Upgrading the Firmware Flash Memory UpgradeUpload Screen Click the Connect button Connect Window appears see FigureConnection Time Out Message Machine is now connectedUpload Connected Upload Progress Restart Message When the update is finished, the restart message appearsChanging the Device Parameters Technical SpecificationsIncludes the technical specifications Technical Specifications1 of the PL-50CR LF Kramer ProtocolProtocol 3000 Syntax Host message formatCommand Command TermsCommon Commands NAME? Name FactoryName NAME?Security Commands Result and Error CodesThese commands are used by network devices running Protocol Network Setting CommandsNET-GATE? NET-DHCPNET-DHCP? NET-GATEInstruction Codes ALARM-START-AS ALARM-OFFALARM-ON ALARM-ON Result ALARM-ON?SCHED? SwitchMES-MODE LVLSWITCH-ORDER-DELAY? SWITCH?SWITCH-ORDER SWITCH-ORDER-DELAYLimited Warranty 2900-000576 REV