Kramer Electronics PL-150 user manual Machine is now connected, Connection Time Out Message

Page 35

Flash Memory Upgrade

3.If you are upgrading using an Ethernet connection, check Ethernet.

To reset the device address to the factory default address, click Default and the address 192.168.1.39 appears.

If you are upgrading using:

RS-232 check Serial, and select the COM port to connect

USB, check USB and select the USB device to connect

4.Click Connect.

Note: If you try to connect to a device and the time out message appears1 (see Figure 32), click CLOSE and verify that the device is powered on, the cable connection is good, the switch on the device is set to “Program”, and that you are trying to connect by the correct method and then click Connect again.

Figure 32: Connection Time Out Message

The machine is now connected:

1 Other Error messages may appear, such as “No USB devices were found” or “This driver is not a valid driver for this unit” and so on

31

Image 35

Contents Model Contents Instruction Codes43 FiguresTables Quick Start IntroductionGetting Started P3K Wizard SoftwareGetting Started Ethernet OverviewYour PL-50 Power Controller Monitor Your PL-50 Power Controller MonitorPL-50 Power Controller Monitor Front Panel Feature Function PL-50 Power Controller Monitor FeaturesBefore Installing in a Rack Installing in a RackConnecting the PL-50 Connecting the PL-50 Power Controller MonitorLocal Area Connection Properties window appears Connecting the RelaysControlling the PL-50 via the Ethernet Port Right-click Local Area Connection PropertiesConnecting via a Straight-Through Cable Upload Main Screen Click the Connect button Connect screen appears as followsIf required, make changes and click Save. If not, click Exit Following window appears Controlling via the Embedded Web PagesRunning the Application Panel Screen Scheduler Screen Scheduler Screen FeaturesHelp BOX Channel Settings Screen Features Define the Channel Settings screenDefine the Alerts screen Alerts Screen FeaturesSetting the Alarms Power Measurement Screen Features Define the Power Measurement screenPower ON/OFF Order Screen This page lets you set the power on and OFF order and delay Configurations Screen Security System Enabled Enable Security SystemSecurity System Calibrating via the Front Panel Buttons Operating Your PL-50 Power Controller MonitorDIP-switch Settings DIP-switch DefinitionsOperating Your PL-50 Power Controller Monitor Upgrading the Firmware Flash Memory UpgradeUpload Screen Click the Connect button Connect Window appears see FigureConnection Time Out Message Machine is now connectedUpload Connected Upload Progress Restart Message When the update is finished, the restart message appearsChanging the Device Parameters Technical SpecificationsIncludes the technical specifications Technical Specifications1 of the PL-50CR LF Kramer ProtocolProtocol 3000 Syntax Host message formatCommand Command TermsCommon Commands NAME? Name FactoryName NAME?Security Commands Result and Error CodesThese commands are used by network devices running Protocol Network Setting CommandsNET-GATE? NET-DHCPNET-DHCP? NET-GATEInstruction Codes ALARM-START-AS ALARM-OFFALARM-ON ALARM-ON Result ALARM-ON?SCHED? SwitchMES-MODE LVLSWITCH-ORDER-DELAY? SWITCH?SWITCH-ORDER SWITCH-ORDER-DELAYLimited Warranty 2900-000576 REV