Compaq CP-2E manual Resetting to Factory Default

Page 49

Advanced Setup Icons

Note: You should change the administrator's user name and password from the default setting immediately for security reasons. Make note of the new user name and password so that you can access the Management Icons of the Connection Point CP-2E in the future.

1.To change the default user name, type a new user name into the Administrator Login Name field.

2.To set a password, type the new password once into the Administrator Login Password field, and again into the Confirm Password field.

Note: Passwords are case-sensitive. Each time you log in, you must use upper and lower-case letters exactly as you entered them when you created the password.

3.Click Apply. The Connection Point CP-2E must be rebooted for applied changes to take effect.

4.Click OK. You can reboot the Connection Point CP-2E at any time by clicking the Reboot button at the left.

Resetting to Factory Default

This procedure restores all factory defaults to the Connection Point CP-2E. Any configuration changes you have made will be lost.

1.On the Connection Point CP-2E Homepage, click Reset Factory Defaults. A confirmation dialog box is displayed.

5–2	iPAQ Connection Point CP-2E User Guide

Image 49

Contents Compaq iPAQ Page Page Contents Connection Point CP-2E Home System Recovery Page Share a Single High-Speed Internet Connection IntroductionSecurity and Advanced Management Ethernet NetworkingIntroduction What Else Do I Need? Description Significance Whats in Front?Description Function Whats in Back?Installation Installation and ConfigurationConnecting to Your PC Connecting to the InternetClient PC Configuration Powering UpConfiguring Windows 98 and ME Clients Installation and Configuration Click the Obtain an IP address automatically radio button Using the Installation Wizard Setting Up Connection Point CP-2EChoosing the Internet Connection Method Dynamic Internet IP Static Internet IP Configuring Dynamic Internet IPPPPoE Configuring Static Internet IPConfiguring PPPoE Timezone Setup Administrator Password Settings Confirming Successful Setup Installing the Firmware Update Utility Registering the Connection Point CP-2E Ethernet PCs Adding PCs To Your NetworkAdding Ethernet PCs Configuring the Client Windows XP ConfigurationAdding PCs To Your Network Adding PCs To Your Network Windows 2000 Configuration Adding PCs To Your Network Adding PCs To Your Network Windows NT4.0 Configuration Adding PCs To Your Network Page Home Page Information Bar Connection Point CP-2E HomeManagement Icons Quick Setup IconSystem Info Icon General InformationLAN Status Internet Status Network Information Event Log Firmware Update Icon Help/Troubleshooting IconRenew Internet IP Icon Page System Settings Advanced Setup IconsPassword Resetting to Factory Default Advanced Setup Icons Internet Timezone SetupChanging the Subnet Click Network Computer List MAC SpoofingDesignating a DMZ Host DMZVirtual Server Adding a Virtual Server Packet Filtering Enabling Packet Filtering Adding an IP Rule Adding Port Rules Dhcp Reserved IP Table Changing Dhcp Server SettingsAdding a Reserved IP Address Excluded IP Addresses Adding an Excluded IP Address Adding a Bootp IP Address Bootpip TableAdvanced Setup Icons Adding a Static Route Static Routing TableAdvanced Setup Icons Smtp Advanced Setup Icons Using the Firmware Update Utility System RecoveryRestore Factory Defaults Solution TroubleshootingCannot Network cables Icon. Then, Renew Internet IP \\computername or \\PC IP Modifications Regulatory ComplianceCables Regulatory Compliance NAT NTP Smtp Appendix a SpecificationsPage For Windows XP Appendix B MAC Address Manual IdentificationFor Windows 98 and ME PCs For Windows 2000 PCs Accessing Security Configuration OptionsPage Glossary IPAQ Connection Point CP-2E User Guide Glossary Glossary Glossary