Compaq CP-2E manual Changing Dhcp Server Settings, Reserved IP Table

Page 62

Advanced Setup Icons

Changing DHCP Server Settings

1. Click the DHCP link at the left. The DHCP page is displayed.

2.Type the information you wish to change into the relevant fields.

3.Select IP Lease Time from pulldown list.

4.Click Apply. The Connection Point CP-2E must be rebooted for applied changes to take effect.

5.Click OK. You can reboot the Connection Point CP-2E at any time by clicking the Reboot button at the left of the Advanced Setup tab.

Reserved IP Table

The Reserved IP Table allows you to assign a specific IP address to a PC on your local network based on its MAC address. The DHCP server assigns the same IP address to the PC every time a new address is requested by the PC. The main page shows IPs that are mapped to specific MAC addresses.

You can add reserved IP addresses; however, you must have the MAC address of each client PC for which you wish reserve an IP address.

iPAQ Connection Point CP-2E User Guide

5–15

Image 62

Contents Compaq iPAQ Page Page Contents Connection Point CP-2E Home System Recovery Page Introduction Share a Single High-Speed Internet ConnectionEthernet Networking Security and Advanced ManagementIntroduction What Else Do I Need? Whats in Front? Description SignificanceWhats in Back? Description FunctionInstallation and Configuration InstallationConnecting to the Internet Connecting to Your PCPowering Up Client PC ConfigurationConfiguring Windows 98 and ME Clients Installation and Configuration Click the Obtain an IP address automatically radio button Choosing the Internet Connection Method Setting Up Connection Point CP-2EUsing the Installation Wizard Dynamic Internet IP Configuring Dynamic Internet IP Static Internet IPConfiguring Static Internet IP PPPoEConfiguring PPPoE Timezone Setup Administrator Password Settings Confirming Successful Setup Installing the Firmware Update Utility Registering the Connection Point CP-2E Adding Ethernet PCs Adding PCs To Your NetworkEthernet PCs Windows XP Configuration Configuring the ClientAdding PCs To Your Network Adding PCs To Your Network Windows 2000 Configuration Adding PCs To Your Network Adding PCs To Your Network Windows NT4.0 Configuration Adding PCs To Your Network Page Connection Point CP-2E Home Home Page Information BarSystem Info Icon Quick Setup IconManagement Icons General InformationLAN Status Internet Status Network Information Event Log Renew Internet IP Icon Help/Troubleshooting IconFirmware Update Icon Page Password Advanced Setup IconsSystem Settings Resetting to Factory Default Advanced Setup Icons Timezone Setup InternetChanging the Subnet MAC Spoofing Click Network Computer ListDMZ Designating a DMZ HostVirtual Server Adding a Virtual Server Packet Filtering Enabling Packet Filtering Adding an IP Rule Adding Port Rules Dhcp Changing Dhcp Server Settings Reserved IP TableAdding a Reserved IP Address Excluded IP Addresses Adding an Excluded IP Address Bootpip Table Adding a Bootp IP AddressAdvanced Setup Icons Static Routing Table Adding a Static RouteAdvanced Setup Icons Smtp Advanced Setup Icons System Recovery Using the Firmware Update UtilityRestore Factory Defaults Troubleshooting SolutionCannot Network cables Icon. Then, Renew Internet IP \\computername or \\PC IP Cables Regulatory ComplianceModifications Regulatory Compliance Appendix a Specifications NAT NTP SmtpPage Appendix B MAC Address Manual Identification For Windows XPFor Windows 98 and ME PCs Accessing Security Configuration Options For Windows 2000 PCsPage Glossary IPAQ Connection Point CP-2E User Guide Glossary Glossary Glossary