Compaq CP-2E manual Regulatory Compliance, Modifications, Cables

Page 78

Regulatory Compliance

8

Regulatory Compliance

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

>Reorient or relocate the receiving antenna.

>Increase the separation between the equipment and receiver.

>Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

>Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Compaq Computer Corporation may void the user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in order to maintain compliance with FCC Rules and Regulations.

iPAQ Connection Point CP-2E User Guide

8–1

Image 78

Contents Compaq iPAQ Page Page Contents Connection Point CP-2E Home System Recovery Page Introduction Share a Single High-Speed Internet ConnectionEthernet Networking Security and Advanced ManagementIntroduction What Else Do I Need? Whats in Front? Description SignificanceWhats in Back? Description FunctionInstallation and Configuration InstallationConnecting to the Internet Connecting to Your PCPowering Up Client PC ConfigurationConfiguring Windows 98 and ME Clients Installation and Configuration Click the Obtain an IP address automatically radio button Setting Up Connection Point CP-2E Using the Installation WizardChoosing the Internet Connection Method Dynamic Internet IP Configuring Dynamic Internet IP Static Internet IPConfiguring Static Internet IP PPPoEConfiguring PPPoE Timezone Setup Administrator Password Settings Confirming Successful Setup Installing the Firmware Update Utility Registering the Connection Point CP-2E Adding PCs To Your Network Ethernet PCsAdding Ethernet PCs Windows XP Configuration Configuring the ClientAdding PCs To Your Network Adding PCs To Your Network Windows 2000 Configuration Adding PCs To Your Network Adding PCs To Your Network Windows NT4.0 Configuration Adding PCs To Your Network Page Connection Point CP-2E Home Home Page Information BarSystem Info Icon Quick Setup IconManagement Icons General InformationLAN Status Internet Status Network Information Event Log Help/Troubleshooting Icon Firmware Update IconRenew Internet IP Icon Page Advanced Setup Icons System SettingsPassword Resetting to Factory Default Advanced Setup Icons Timezone Setup InternetChanging the Subnet MAC Spoofing Click Network Computer ListDMZ Designating a DMZ HostVirtual Server Adding a Virtual Server Packet Filtering Enabling Packet Filtering Adding an IP Rule Adding Port Rules Dhcp Changing Dhcp Server Settings Reserved IP TableAdding a Reserved IP Address Excluded IP Addresses Adding an Excluded IP Address Bootpip Table Adding a Bootp IP AddressAdvanced Setup Icons Static Routing Table Adding a Static RouteAdvanced Setup Icons Smtp Advanced Setup Icons System Recovery Using the Firmware Update UtilityRestore Factory Defaults Troubleshooting Solution Cannot Network cables Icon. Then, Renew Internet IP \\computername or \\PC IP Regulatory Compliance ModificationsCables Regulatory Compliance Appendix a Specifications NAT NTP SmtpPage Appendix B MAC Address Manual Identification For Windows XPFor Windows 98 and ME PCs Accessing Security Configuration Options For Windows 2000 PCsPage Glossary IPAQ Connection Point CP-2E User Guide Glossary Glossary Glossary