Compaq CP-2E manual Bootpip Table, Adding a Bootp IP Address

Page 66

Advanced Setup Icons

3.Type the IP address that you wish to exclude into the IP Address field.

4.If you wish, you can type a brief description into the Comment field.

5.Click Apply. The Connection Point CP-2E must be rebooted for applied changes to take effect.

6.Click OK. You can reboot the Connection Point CP-2E at any time by clicking the Reboot button at the left.

BOOTPIP Table

The BOOTP IP Table allows you to reserve IP addresses for devices that use the BOOTP protocol for TCP/IP network configuration. These values are based on MAC addresses.

You must have the MAC address of each client device for which you wish reserve an IP address.

Adding a BOOTP IP Address

1. Click BOOTP IP Table. The BOOTP IP Table page is displayed.

iPAQ Connection Point CP-2E User Guide

5–19

Image 66

Contents Compaq iPAQ Page Page Contents Connection Point CP-2E Home System Recovery Page Introduction Share a Single High-Speed Internet ConnectionEthernet Networking Security and Advanced ManagementIntroduction What Else Do I Need? Whats in Front? Description SignificanceWhats in Back? Description FunctionInstallation and Configuration InstallationConnecting to the Internet Connecting to Your PCPowering Up Client PC ConfigurationConfiguring Windows 98 and ME Clients Installation and Configuration Click the Obtain an IP address automatically radio button Setting Up Connection Point CP-2E Using the Installation WizardChoosing the Internet Connection Method Dynamic Internet IP Configuring Dynamic Internet IP Static Internet IPConfiguring Static Internet IP PPPoEConfiguring PPPoE Timezone Setup Administrator Password Settings Confirming Successful Setup Installing the Firmware Update Utility Registering the Connection Point CP-2E Adding PCs To Your Network Ethernet PCsAdding Ethernet PCs Windows XP Configuration Configuring the ClientAdding PCs To Your Network Adding PCs To Your Network Windows 2000 Configuration Adding PCs To Your Network Adding PCs To Your Network Windows NT4.0 Configuration Adding PCs To Your Network Page Connection Point CP-2E Home Home Page Information BarSystem Info Icon Quick Setup IconManagement Icons General InformationLAN Status Internet Status Network Information Event Log Help/Troubleshooting Icon Firmware Update IconRenew Internet IP Icon Page Advanced Setup Icons System SettingsPassword Resetting to Factory Default Advanced Setup Icons Timezone Setup InternetChanging the Subnet MAC Spoofing Click Network Computer ListDMZ Designating a DMZ HostVirtual Server Adding a Virtual Server Packet Filtering Enabling Packet Filtering Adding an IP Rule Adding Port Rules Dhcp Changing Dhcp Server Settings Reserved IP TableAdding a Reserved IP Address Excluded IP Addresses Adding an Excluded IP Address Bootpip Table Adding a Bootp IP AddressAdvanced Setup Icons Static Routing Table Adding a Static RouteAdvanced Setup Icons Smtp Advanced Setup Icons System Recovery Using the Firmware Update UtilityRestore Factory Defaults Troubleshooting SolutionCannot Network cables Icon. Then, Renew Internet IP \\computername or \\PC IP Regulatory Compliance ModificationsCables Regulatory Compliance Appendix a Specifications NAT NTP SmtpPage Appendix B MAC Address Manual Identification For Windows XPFor Windows 98 and ME PCs Accessing Security Configuration Options For Windows 2000 PCsPage Glossary IPAQ Connection Point CP-2E User Guide Glossary Glossary Glossary