Compaq CP-2E manual Advanced Setup Icons

Page 69

Advanced Setup Icons

3.Type the destination IP address to which you wish to assign a specified route into the Network Address field.

4.Type the subnet mask associated with the destination IP address into the Subnet Mask field. This determines which part of the destination IP address is the network portion, and which is the host portion.

5.Type the IP address of the gateway device that is used to contact the destination IP address into the Gateway field. If the destination address is on the LAN, this gateway IP address must be in the range of the assigned DHCP addresses for the LAN.

6.Select the LAN Ethernet or WAN from the Interface pulldown menu. If you are connecting to a local subnet, select LAN. If you are connecting to another computer through the internet, select WAN.

7.Click Apply. The Connection Point CP-2E must be rebooted for applied changes to take effect.

8.Click OK. You can reboot the Connection Point CP-2E at any time by clicking the Reboot button at the left.

5–22	iPAQ Connection Point CP-2E User Guide

Image 69

Contents Compaq iPAQ Page Page Contents Connection Point CP-2E Home System Recovery Page Share a Single High-Speed Internet Connection IntroductionSecurity and Advanced Management Ethernet NetworkingIntroduction What Else Do I Need? Description Significance Whats in Front?Description Function Whats in Back?Installation Installation and ConfigurationConnecting to Your PC Connecting to the InternetClient PC Configuration Powering UpConfiguring Windows 98 and ME Clients Installation and Configuration Click the Obtain an IP address automatically radio button Setting Up Connection Point CP-2E Using the Installation WizardChoosing the Internet Connection Method Dynamic Internet IP Static Internet IP Configuring Dynamic Internet IPPPPoE Configuring Static Internet IPConfiguring PPPoE Timezone Setup Administrator Password Settings Confirming Successful Setup Installing the Firmware Update Utility Registering the Connection Point CP-2E Adding PCs To Your Network Ethernet PCsAdding Ethernet PCs Configuring the Client Windows XP ConfigurationAdding PCs To Your Network Adding PCs To Your Network Windows 2000 Configuration Adding PCs To Your Network Adding PCs To Your Network Windows NT4.0 Configuration Adding PCs To Your Network Page Home Page Information Bar Connection Point CP-2E HomeManagement Icons Quick Setup IconSystem Info Icon General InformationLAN Status Internet Status Network Information Event Log Help/Troubleshooting Icon Firmware Update IconRenew Internet IP Icon Page Advanced Setup Icons System SettingsPassword Resetting to Factory Default Advanced Setup Icons Internet Timezone SetupChanging the Subnet Click Network Computer List MAC SpoofingDesignating a DMZ Host DMZVirtual Server Adding a Virtual Server Packet Filtering Enabling Packet Filtering Adding an IP Rule Adding Port Rules Dhcp Reserved IP Table Changing Dhcp Server SettingsAdding a Reserved IP Address Excluded IP Addresses Adding an Excluded IP Address Adding a Bootp IP Address Bootpip TableAdvanced Setup Icons Adding a Static Route Static Routing TableAdvanced Setup Icons Smtp Advanced Setup Icons Using the Firmware Update Utility System RecoveryRestore Factory Defaults Solution TroubleshootingCannot Network cables Icon. Then, Renew Internet IP \\computername or \\PC IP Regulatory Compliance ModificationsCables Regulatory Compliance NAT NTP Smtp Appendix a SpecificationsPage For Windows XP Appendix B MAC Address Manual IdentificationFor Windows 98 and ME PCs For Windows 2000 PCs Accessing Security Configuration OptionsPage Glossary IPAQ Connection Point CP-2E User Guide Glossary Glossary Glossary