How to use ADVANCED MENU
INPUT RESOLUTION
Input resolution adjustment achieves the best image when the screen flickers or halo is observed around the contour.
: These select the items listed below.
: These select the value.
“TOTAL DOTS”, “DISPLAY DOTS”, “TOTAL LINES” and “DISPLAY LINES”
Each item automatically displays a value in response to the type of the input signal. If vertical stripes appear on the screen or the image is partly missing, increase or decrease the displayed value while observing the screen to achieve the optimal value.
Note • The abovementioned vertical stripes will not appear on the screen when all white signals are input.
•The picture may be distorted during the adjusting operation, but this is not a fault.
•The input resolution can be adjusted only when RGB signal input is applied with RGB1 and RGB2 IN.
•Automatic adjustment is not available if signals having a dot clock frequency of more than 150 MHz are supplied.
CLAMP POSITION
(For RGB/YPBPR signals only)
Use the clamp position adjustment to achieve the optimal value when dark areas of the image are crushed or displayed in green.
Adjust with the 
buttons. The value changes from 0 to 255.
The optimal value for the clamp position adjustment
•If dark areas are crushed:
The optimal value is the point where the dark area is best improved.
•If the dark areas are displayed in green:
The optimal value is the point where the green area becomes dark and clear.
Note • The clamp position can be adjusted only when the RGB signal input is applied with RGB1 and RGB2 IN.
RASTER POSITION
When the whole area where the input picture can be displayed is not used, the picture can be moved to any position inside the display area.
: These adjust the value in the horizontal direction.
: These adjust the value in the vertical direction.
XGA MODE
This mode takes effect only when XGA (RGB) signals are input.
XGA : This is the standard setting.
WXGA : Select this mode when WXGA signals are input.
SXGA MODE
This mode takes effect only when SXGA (RGB) signals are input.
SXGA : This is the standard setting.
SXGA+: Select this when the screen is cut off.
Changing the display language
DISPLAY LANGUAGE
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
日本語
中文
SELECT
SET
Menus, setting items, adjustment screens, and control button names will be displayed in the language the user chooses.
The available languages are:
ENGLISH, DEUTSCH, FRANÇAIS, ESPAÑOL,
ITALIANO, 
, 
, 
, 
.
Note • The projector’s
30