Planar PR9020 user manual Audio Menu

AUDIO Menu

AUDIO Menu

From the AUDIO menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.

NOTE • The speaker sound may distorted or the case may be trembling when the volume is too high or treble/bass is emphasized or WOW is activated. In that case, make the volume reduced, bass/treble low or WOW effect to be weakend.

Item	Description
VOLUME	Using the ▲/▼ buttons adjusts the volume.
	High ó Low
TREBLE	Using the ▲/▼ buttons adjusts the treble level.
	High ó Low
BASS	Using the ▲/▼ buttons adjusts the bass level.
	High ó Low
	Using the ▲/▼ buttons switches the mode for SRS WOW mode.
SRS WOW	HIGH ó MID ó OFF
	• SRS WOW™ accomplishes this by providing a panoramic three-
	dimensional audio image that extends the sound field in both the
	horizontal and vertical planes, and lowers the perceived bass
	response well beyond the low frequency limitations of the drivers.
	Adjust it depending on the user's preference.
SPEAKER	Using the ▲/▼ buttons turns the speaker function on/off.
	TURN ON ó TURN OFF
	• When the TURN ON is selected the built-in speaker works.

Allocates the audio ports.

(1)Choose a picture input port using the ▲/▼ buttons.

RGB1 ó RGB2 ó HDMI

QUIT ó VIDEO ó S-VIDEO ó COMPONENT

	(2) Select the audio port to be interlocked with
AUDIO	the input port using the ◄/► buttons.
	1 ó 2 ó 3 ó 4 ó ó H

•H is abbreviation of HDMI.

•H can be selected for HDMI port only. When H is selected, the audio signal to HDMI port will be output if HDMI is chosen as a display source.

•When is selected for an input, the audio will not be output if the input is chosen as a display source.

HDMI AUDIO	The HDMI AUDIO is set to 1 as default. In case the HDMI audio
	does not work well, try 2.
	1 ó 2

37