Planar PR9020 Using the Transition Detector Function, Turning On the Transition Detector Function

ENTER PASSWORD BOX

(small)

PASSWORD AGAIN BOX

NOTE PASSWORD BOX

OPTION Menu

OPTION Menu (continued)

Item

Description

4. Using the Transition Detector Function

While the Transition Detector function is ON, when power switch is started to supply to the projector, it might react as below.

•Transition Detector alarm shown below might appear on screen, if the projector has been moved or re-installed.

•Transition Detector alarm might appear on screen, if the MIRROR setting has been changed.

•Keystone adjustment feature has been prohibited as long as the Transition Detector function is ON.

4.1 Turning On the Transition Detector Function

4.1-1 Use the ▲/▼ buttons on the SECURITY menu to select Transition Detector and press the ► or the ENTER button to display the Transition Detector on/off menu. Select TURN ON and the current angle and mirror setting will be recorded.

•This feature may not function properly if the projector is not in a stable position when TURN ON is selected.

4.1-2 If this function is set to TURN ON when the vertical angle of the projector or mirror setting at which the projector is turned on is different than the previously recorded the Transition Detector Alarm will be displayed and the projector will not display the input signal.

Transition Detector

on/off menu

Transition Detector Alarm

SECURITY (continued)

Set the Transition Detector off in the SECURITY menu to display the input signal.

If the Transition Detector ALARM is displayed for about 5 minutes the lamp will turn off. This function will activate only when the projector is started after the power switch was turned off.

4.2 Setting the Transition Detector PASSWORD

4.2-1 Use the ▲/▼ buttons on the SECURITY menu to select Transition Detector and press the ► or the ENTER button to display the Transition Detector on/off menu.

4.2-2 Use the ▲/▼ buttons on the Transition Detector on/off menu to select TURN ON. The ENTER PASSWORD BOX (small) will be displayed.

4.2-3 Use the ▲/▼/◄/► buttons to enter a PASSWORD. Move the cursor to the right side of the ENTER PASSWORD BOX (small) and press the ► button to display the PASSWORD AGAIN BOX, enter the same PASSWORD again.

4.2-4 Move the cursor to the right side of the PASSWORD AGAIN BOX and press the

►button to display the PASSWORD for about 20 seconds, please make note of the

PASSWORD during this time.

Pressing the ENTER button on the remote control or the INPUT button on the projector will return to the Transition Detector on/off menu.

• Please do not forget your Transition Detector PASSWORD.

(continued on next page)

51