Onkyo 29400095 Specifications, Amplifier Section, Video Section, Tuner Section, General

Page 101

Specifications

Amplifier Section

Rated Output Power
All channels:	80 watts minimum continuous power
	per channel, 8 ohm loads, from 20 Hz
	to 20 kHz with a maximum total
	harmonic distortion of 0.08%.
	90 watts minimum continuous power
	per channel, 8 ohm loads, at 1 kHz
	with a maximum total harmonic
	distortion of 0.7%.
	130 watts minimum continuous
	power per channel, 6 ohm loads, at
	1 kHz with a maximum total
	harmonic distortion of 1%.
Dynamic Power	180 W (3 Ω, Front)
	160 W (4 Ω, Front)
	100 W (8 Ω, Front)
THD (Total Harmonic Distortion)
	0.08% (Power Rated)
Damping Factor	60 (Front, 1 kHz, 8 Ω)

Input Sensitivity and Impedance

200mV/47 kΩ (LINE)

Output Level and Impedance

	200 mV/2.2 kΩ (REC OUT)
Frequency Response	5 Hz - 100 kHz/+1 dB, - 3 dB (Direct
	mode)
Tone Control	±10 dB, 50 Hz (BASS)
	±10 dB, 20 kHz (TREBLE)
Signal to Noise Ratio	106 dB (LINE, IHF-A)
Speaker Impedance	6 Ω - 16 Ω

Video Section

Input Sensitivity/Output Level and Impedance

1Vp-p/75 Ω

(Component Y)

0.7 Vp-p/75 Ω (Component PB/CB, PR/CR)

1Vp-p/75 Ω (Composite)

Component Video Frequency Response

5 Hz - 50 MHz, - 3 dB

Tuner Section

FM Tuning Frequency Range

87.5MHz - 107.9 MHz

AM Tuning Frequency Range

	530 kHz - 1710 kHz
Preset Channel	40

General

Power Supply	AC 120 V, 60 Hz
Power Consumption	5.5 A
Dimensions (W ⋅ H ⋅ D)
	435 ⋅ 176 ⋅ 329 mm
	(17-1/8" ⋅ 6-15/16" ⋅ 12-15/16")
Weight	10.8 kg (23.8 lbs.)
■ Video Inputs
HDMI	IN 1, IN 2, IN 3, IN 4, IN 5
Component	IN 1, IN 2
Composite	DVD/BD, VCR/DVR, CBL/SAT,
	GAME, AUX
■ Video Outputs
HDMI	OUT
Component	OUT
Composite	MONITOR OUT, VCR/DVR
	(REC OUT)
■ Audio Inputs
Digital Inputs	Optical: 2
	Coaxial: 2
Analog Inputs	DVD/BD, VCR/DVR, CBL/SAT,
	GAME, AUX (PORTABLE),
	TV/TAPE, CD
■ Audio Outputs
Analog Outputs	TV/TAPE, VCR/DVR,
	ZONE 2 LINE OUT
Subwoofer Pre Outputs
	2
Speaker Outputs	Main (L, R, C, SL, SR, SBL, SBR)
	+ ZONE2 (L, R)/ Front High (L, R)
Phones	1

■Control Terminal

MICYes

Specifications and features are subject to change without notice.

101

Image 101

Contents HT-RC160 Avis Important Safety InstructionsPower PrecautionsPreventing Hearing Loss Caution Batteries and Heat Exposure WarningSpeaker cable labels Supplied AccessoriesMake sure you have the following accessories Contents Amplifier FeaturesProcessing ConnectionsMain Room Multiroom CapabilityZone 2 Room Front high left and right speakersFront Panel Front & Rear PanelsDisplay Front & Rear PanelsRear Panel Game TV/TAPE IN/OUTCBL/SAT VCR/DVR IN/OUTAiming the Remote Controller Remote ControllerInstalling the Batteries Controlling the AV Receiver Remote ControllerEnjoying Home Theater About Home TheaterFront left and right speakers Center speakerConnecting Your Speakers Connecting the AV ReceiverSpeaker Configuration Using Dipole SpeakersConnecting a Powered Subwoofer Connecting the AV ReceiverSpeaker Connection Precautions Connecting the Speaker CablesFront high Bi-amping Speaker Hookup Bi-amping the Front SpeakersConnecting the Indoor FM Antenna Connecting AntennaConnecting the AM Loop Antenna Attach the FM antenna, as shownUsing a TV/FM Antenna Splitter Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna AV Cables & Jacks About AV ConnectionsOptical Digital Jacks AV Connection Color Coding About Hdmi Connecting Components with HdmiSupported Audio Formats About Copyright ProtectionAudio Signals Video SignalsMaking Hdmi Connections StepVideo Connection Formats Connecting Both Audio & VideoWhich Connections Should I Use? Signal Selection Example Signal SelectionDVD/BD player, etc Audio Signal Flow Chart Audio Connection FormatsVideo Connection Connecting a TV or ProjectorAudio Connection TV, projector EtcDVD/BD player Connecting a DVD/BD PlayerDVD/BD recorder Connecting a VCR or DVD/BD Recorder for PlaybackRecorder Connecting a VCR or DVD/BD Recorder for RecordingMake the audio connection a Satellite, cable, set-top box, etc Digital in Optical 2 CDGame Console Connecting a Game ConsoleConnecting a Portable Audio player Connecting a Camcorder or Other DeviceMake the connection a Make the audio connection aCD Player or Turntable MM with Built-in Phono Preamp Step Connecting a CD Player or TurntableAn MC head amp and phono preamp are necessary to Phono preamp is necessary to connect a turntable thatConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting a Dock with the Universal Port connector Connecting an RI DockIf Your iPod Supports Video If Your iPod Doesn’t Support VideoConnecting the Power Cord Connecting Onkyo u ComponentsAuto Power On/Standby Make the uconnection see illustration belowTurning On and Standby Turning On the AV ReceiverSmooth Operation in a Few Easy Steps Have you connected an Onkyo RI Dock?Using the Display to change the settings First Time SetupUsing the Onscreen Setup Menus Onscreen Setup Menus and DisplayHdmi Input Setup First Time SetupVideo Input Setup Tons to select 2. Component Component Video SetupVideo Input, and then press Then use the Left and Right e/r buttons to selectInput, and then press Enter Digital Input SetupTons to select 3. Digital Audio Powered Zone Speaker SettingsPress the Receiver button Followed by the Setup button Tons to select 1. Speaker SetPress the Receiver button FM/AM Frequency Step SetupTons to select 2. Tuner, Use the Left and Right e/r Buttons to select 200kHz/10kHzChanging the Input Display Measurement Positions Audyssey 2EQ Room Correction and Speaker SetupFirst measurement point Second measurement pointWhen you’ve finished, press the Enter button Using Audyssey 2EQTurn on the AV receiver Connected TVPress Enter CancelFollowing screen appears SaveDisconnect the speaker setup Error MessagesSpeaker Detect Error MicrophoneUsing a Powered Subwoofer Changing the Speaker Settings ManuallySpeaker matching error Writing ErrorSee Using the Listening Modes on Select a listening mode and enjoyBasic Operations Selecting the Input SourceSetting the Display Brightness Adjusting the Bass & TrebleBasic Operations Displaying Source InformationUsing Headphones Using the Sleep TimerMuting the AV receiver You can temporarily mute the output of the AV receiverTuning into Radio Stations Using the TunerListening to the Radio Listening to the RadioSelecting Presets Presetting AM/FM StationsDeleting Presets Listening to the RadioAbout the UP-A1 series Dock UP-A1 series Dock for iPodCompatible iPod models Putting Your iPod in the DockCharging Your iPod models Battery Using Your iPod models Alarm ClockUP-A1 series Dock for iPod Controlling iPodStatus messages Recording Separate AV Sources RecordingAV Recording Selecting with the Remote Controller Using the Listening ModesSelecting Listening Modes Selecting on the AV receiverListening Modes Available for Each Source Format Using the Listening ModesMono/Multiplex Sources Available Listening ModesStereo Source Direct Stereo Mono DolbyDigital Plus/TrueHD Multichannel Channel SourcesPLIIx Movie PLIIx MusicDTS-ES Discrete/Matrix Sources Resolution Audio/DTS-HD Master Audio PLIIz HeightDirect Discrete DTS-ES MatrixAbout the Listening Modes Onkyo Original DSP Modes Onscreen Setup Menus Advanced SetupMain menu Submenus PagesSpeaker Setup Advanced SetupCommon Procedures in Setup Menu Double Bass*9 LPF of LFESpeaker Distance Unit FeetLevel calibration Equalizer SettingsPress the Down w button to select Channel, and then use Left and Right e/ r buttons to select a speakerMultiplex/Mono Settings Audio AdjustDolby Settings PLIIx Music 2ch Input Dolby EXTheater-Dimensional Setting DTS Setting Neo6 MusicAudyssey Settings Using the Audio Settings CinemaFILTER Audyssey Dynamic VolumeMusic Optimizer Speaker LayoutSignal format selection menu appears Listening Mode Preset menu appearsWhen you’ve finished, press the Setup button Assigning Listening Modes to Input SourcesSync Source SetupIntelliVolume To correct a character Name EditOSD Setup Miscellaneous Volume/OSD SetupVolume Setup Tuner Hardware SetupRemote ID Color Power ControlHdmi Control Rihd Disconnect → Rihd OffUsing the Video Settings Lock SetupDigital Input Signal Formats Connecting Your Zone 2 Speakers Directly to the AV receiver Connecting ZoneConnecting Your Zone 2 Speakers to an Amp in Zone ZoneButtons to select Powered Setting the Powered ZoneUse the Up and Down q/ w Zone 2, and use the Left Right e/r buttons to selectControlling Zone 2 from the AV receiver Using ZoneControlling Zone 2 with the Remote Controller Muting Zones Adjusting the Volume for ZoneZone 2 button, and then Use the VOL q/ w buttonLooking up for Remote Control Code Preprogrammed Remote Control CodesController Setup, and then Controlling Other ComponentsControlling Other Components Remote Mode Setup menuIf you can control component Buttons to select Works,Entering Remote Control Codes Resetting the Remote Controller Remote Control Codes for Onkyo Components Connected via uResetting Remote Mode Buttons Controlling a TV Controlling a DVD/BD Player, or DVD/BD Recorder Playback button Play Mode buttonControlling a VCR or PVR Controlling a Satellite Receiver or Cable Receiver Disc +/- button Controlling a CD PlayerWorks as a Mode button when used with a DS-A2 RI Dock When Using an RI DockControlling an RI Dock Turns on the backlight for 30 secondsPrevious and Next 7/6 buttons Controlling a Cassette RecorderRewind and Fast Forward 5/4 buttons Reverse Play t buttonTroubleshooting Troubleshooting AV receiver’s remote controller doesn’t control your iPod Remote Controller Remote controller doesn’t workThere’s no picture from a source connected to an Hdmi Onscreen menus don’t appearRecording Can’t record Others Sound changes when I connect my headphonesZone There’s no sound How do I change the language of a multiplex sourceAmplifier Section SpecificationsVideo Section Tuner SectionVideo Resolution Chart 103 MemoOnkyo Europe UK Office Onkyo Europe Electronics GmbH