Onkyo 29400095 Basic Operations, Adjusting the Bass & Treble, Displaying Source Information

Basic Operations—Continued

–, +, TONE

DISPLAY

Press

[RECEIVER] first

DIMMER

Adjusting the Bass & Treble

You can adjust the bass and treble for the front speakers, except when the Direct listening mode is selected.

1		Press the [TONE] button repeat-
	AV receiver	edly to select either “Bass” or
		“Treble”.

2	Use the TONE [–]/[+] buttons to
	adjust.

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

Note:

This procedure can also be performed on the remote con- troller by using [AUDIO] button (see page 72).

Displaying Source Information

You can display various information about the current input source as follows.

Remote	Press the [RECEIVER] button,
controller	and then press the [DISPLAY]
	button repeatedly to cycle
	through the available informa-
	tion.

Note:

This procedure can also be performed on the AV receiver by using its [DISPLAY] button.

The following information can typically be displayed for input sources.

Input source & volume*1

Signal format*2 or sampling frequency

Input source & listening mode

*1 When AM or FM radio is used, the band, preset number, and frequency are displayed.

*2 If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed.

Information is displayed for about three seconds, then the previ- ously displayed information reappears.

Setting the Display Brightness

You can adjust the brightness of the AV receiver’s dis- play.

Remote	Press the [RECEIVER] button,
controller	and then press the [DIMMER]
	button repeatedly to select: dim,
	dimmer, or normal brightness.
	Alternatively, you can use the AV
	receiver’s [DIMMER] button.

51