Onkyo Complete Guide to the UP-A1 Series Dock for iPod

UP-A1 series Dock for iPod

About the UP-A1 series Dock

With the UP-A1 series Dock, you can easily play the music, photo, or movie stored on your Apple iPod through the AV receiver and enjoy great sound. You can use the AV receiver’s remote controller to operate your iPod.

For the latest information on the Dock, see the Onkyo Web site at: www.onkyo.com

Adapter

■Adjusting the Adapter

The adapter needs to be adjusted to match your particu- lar iPod. If there’s a gap between the back of your iPod and the adapter, turn the adapter counterclockwise to close the gap. Turning the adapter counterclockwise moves it forward. Turning it clockwise moves it back- ward.

Forward

Backward

	Notes:
	• Make sure that the output level of the AV receiver is
		set to minimum.
	• To prevent damage to the dock connector, don’t twist
Dock connector		your iPod when inserting or removing it, and be care-
		ful not to knock over the dock while your iPod is
Compatible iPod models		inserted.
For information about which iPod models are sup-	•	Do not take off your iPod from the Dock when you
		play back the music, photo, or movie stored on your
ported by the UP-A1 series Dock, see the UP-A1 series
		iPod.
Dock’s instruction manual.
	• Don’t use the UP-A1 with any other iPod accessories,
Note:		such as FM transmitters and microphones, because
Before using the UP-A1 series Dock, update your iPod		they may cause a malfunction.
with the latest software, available from the Apple Web	•	It is recommended that you update your iPod software
site.		before using it with this unit. The updater for the iPod
		software is available at the Apple website.

Putting Your iPod in the Dock

1Turn on the AV receiver, and select the [PORT] selector.

2Align your iPod with the Dock connector and push it down so that it’s fully seated.

Remove iPod case before

inserting

Function Overview

■Basic Operation

Note:

The AV receiver may take several seconds to startup, so you might not hear the first few seconds of the first song.

• Auto Power On Function

If you start iPod playback while the AV receiver is on Standby, the AV receiver will automatically turn on and select your iPod as the input source. Then, your iPod will start playback.

• Direct Change Function

If you start iPod playback while listening to another input source, the AV receiver will automatically select your iPod as the input source.

• Using the AV receiver’s Remote Controller

You can use the AV receiver’s remote controller to control basic iPod functions.

55