Hardware Installation 
1.Pull the “tabs” which are at the ends of the socket to the side.
2.Position the DIMM above the socket with the “notches” in the module aligned with the “keys” on the socket.
3.Seat the module vertically into the socket. Make sure it is completely seated. The tabs will hold the DIMM in place.
2.3DIP Switch Settings for Processors (For Factory Use Only)
You cannot overclock an Intel CeleronTM PPGA processor because its frequency ratio has been fixed by the manufacturer. Therefore SW1 on the system board is used for factory testing only. The table on the next page, which shows the supported processors and their corresponding DIP switch settings, are for reference.
In the example above:
Switch 1: Off
Switch 2: On
Switch 3: Off
Switch 4: On
14