
Hardware Installation 
































Connecting the Hard Disk Cable
1.If you are connecting two hard drives, install the
of the IDE cable into the primary shrouded
IDE header (connector J8). If you are adding a
third or fourth IDE
device, install the 40- pin connector of the other IDE cable into
the secondary
shrouded IDE header (connector J7).
2.Install the other
Note:
Refer to your disk drive user’s manual for information about selecting proper drive switch settings.
Adding a Second IDE Hard Drive
When using two IDE drives, one must be set as the master and the other as the slave. Follow the instructions provided by the drive manufacturer for setting the jumpers and/or switches on the drives.
We recommend that you use Enhanced IDE or
Important:
If you encountered problems while using an ATAPI
22