Page 17
Hardware Installation
2.6Jumper Settings for Wake-On-Keyboard/ Wake-On-Mouse (ATX power supply only)
Jumper JP1
Wake-On-Keyboard/Wake-On-Mouse
The system board supports the Wake-On-Keyboard/Wake- On-Mouse function. This function allows you to use the keyboard or mouse to power- on the system. By default, JP1 is disabled. To use this function, set JP1 to 2-3 On. “Keyboard/ Mouse Power On” in the Integrated Peripherals setup of the Award BIOS must be set accordingly. Refer to chapter 3 for details.
Warning:
1. If JP1 was previously enabled with a password set in the “KB Power On Password” field, and now you wish to disable the Wake-On-Keyboard (password) function, make sure to set the “Keyboard/Mouse Power On” field to Disabled prior to setting JP1 to disabled. You will not be able to boot up the system if you fail to do so.
2.The power button will not function once a keyboard password has been set in the “KB Power On Password” field of the Integrated Peripherals setup. You must type the correct password to power-on the system.
3.The 5VSB power source of your power supply must support ≥ 720mA (minimum).
3 2 13 2 1
| | | | | | | | |
1-2 On: Disable | 2-3 On: Enable |
(default) | | | | | |
17
