Nokia M1112 manual Ethernet interface, Adsl interface, Signal Direction MDI signal

M1112 Administrator Manual

3.1.1 Ethernet interface

The Ethernet interface (ETH) is located on the back panel. The Ethernet interface is a standard 10 Mbit/s half-duplex 10Base-T interface. The mechanical connector is an 8-pin RJ-45. The pin-out numbering is shown in Table 3-1.

1 8

Figure 3-2	ETH connector
PIN	Signal	Direction	MDI signal
		M1112-
		Ethernet
1	Rx+	<–	Receive data +
2	Rx–	<–	Receive data –
3	Tx+	–>	Transmit data +
6	Tx–	–>	Transmit data –

Table 3-1Ethernet interface pin-out numbering

3.1.2 ADSL interface

The ADSL interface (DSL) is compatible with ETSI TS 101 388 specification. The mechanical connector is a 6-pin RJ-11. The pin-out numbering is shown in Table 3-2.

1 6

Figure 3-3DSL connector

3-2 E Copyright Nokia Networks Oy C33907001SE_00