Nokia manual M1112 Administrator Manual

M1112 Administrator Manual

The command line interface has been divided into two modes: main and configuration. The main mode lets you monitor the status and performance of M1112. The configuration mode lets you change M1112 configuration. The CLI is case sensitive. All commands must be given in lower case characters. Only file names and strings can contain upper case characters.

In the configuration mode, functions can be activated by typing the corresponding command, for example bridging. The function can be deactivated by simply typing no bridging. In commands which require typing in parameter values, the default value can be restored by typing de ppp mru, for example. de in front of the command means “default”. If you type in a value which is incorrect (for example, letters instead of numbers), the CLI prompts you to enter the value correctly and displays help. You can always get help on the command or display by typing help or ? at the command prompt.

You can recall you previous commands by pressing the “up-arrow” key on your keyboard.

The configuration mode has been divided into levels. You can navigate through the configuration mode by typing the name of the level. By typing exit you will return to the main mode. top command returns you to the root level of the configuration mode (M1112(conf)#).

The configuration mode levels are:

Dsystem

Dpassword

Deth

Dvcc1, vcc2, vcc3, vcc4, vcc5, vcc6, vcc7, and vcc8

Dvbridge

Dmngtvcc

Dcommon.

The example below shows how to access the different levels:

M1112>

M1112>conf

M1112(conf)#system

M1112(conf-system)#password

M1112(conf-password)#eth

M1112(conf-eth)#vcc1

M1112(conf-vcc1)#vcc2

M1112(conf-vcc2)#vcc3

M1112(conf-vcc3)#vcc4

5-22 E Copyright Nokia Networks Oy C33907001SE_00