Nokia M1112 manual Setting Value

Managing M1112

Setting		Value
Speed		9600
Parity		None
Data bits		8
Stop bits		1
Duplex		Full
Flow control		None
Table 5-1	Local management console configuration

Use the 10Base-T Ethernet cable with the serial adapter to connect you PC’s serial port to the local management console interface according to Figure 5-12.

10Base-T Ethernet cable

serial adapter

Figure 5-12Local management cabling

The command line interface can also be accessed through the Ethernet port of M1112 or through the ATM channels of M1112 on top of the telnet protocol. In order to use the CLI through telnet or the ATM channel, the IP function must be switched on and IP address must be given to the corresponding interface.

M1112 can also be managed remotely through a separate ATM virtual channel. This channel is only used for management purposes. In order to use this management channel, it has to be activated first and given an IP address configuration. The management traffic to this interface is not routed to any other interfaces of M1112.

C33907001SE_00 E Copyright Nokia Networks Oy 5-21