Nokia M1112 manual Step-by-step installation procedure

Installing Nokia M1112

4.2Step-by-step installation procedure

1.Plug the mains power cord to a mains outlet.

2.Switch on M1112. The PWR indicator lights up.

3.Connect the 8-pin Ethernet cable between your PC’s 10 Base-T Ethernet card and the Ethernet connector on the M1112 back panel.

4.Switch on your PC. The indicator corresponding the Ethernet port you connected your PC to becomes green when your PC has started. This indicator blinks when there is traffic in the corresponding Ethernet port.

5.Connect the 6-pin ADSL line cable between the ADSL connector on the M1112 back panel and your ADSL line wall socket. If you want to use ISDN and ADSL data services simultaneously, connect a splitter according to Figure 4-1. After a while, the DSL indicator starts blinking indicating that the ADSL connection is being established. After the connection has been established successfully the DSL indicator remains lit.

6.During normal operation PWR and DSL indicators are lit and the Ethernet indicators of the active Ethernet ports blink or are lit depending whether there is traffic or not. COL indicator may blink occasionally during normal operation.

S int.

ISDN NT1

U int.

splitter

Figure 4-1M1112 and splitter connected

Now, your M1112 has been connected and you can check the connections according to your service provider’s instructions. See

C33907001SE_00 E Copyright Nokia Networks Oy 4-3