JVC DLA-SX21E, DLA-SX21SU Connecting to Various Devices,
Allowable input signals, Signal

Connecting to Various Devices

Allowable input signals

		Signal	Horizontal resolution	Vertical resolution	Horizontal frequency	Vertical frequency
			Hor[Pixels]	Ver [Lines]	H [kHz]	V [Hz]
	PC98	VESA350	640	350	37.86	84.13
	PC/AT	PC98	640	400	24.83	56.42
	DOS/V	VGA 60Hz*	640	480	31.47	59.94
	DVI*	VGA 72Hz*	640	480	37.86	72.81
		VGA 75Hz*	640	480	37.50	75.00
		VGA 85Hz*	640	480	43.27	85.01
		SVGA 56Hz*	800	600	35.16	56.25
		SVGA 60Hz*	800	600	37.88	60.32
		SVGA 72Hz*	800	600	48.08	72.19
		SVGA 75Hz*	800	600	46.88	75.00
		SVGA 85Hz*	800	600	53.67	85.06
system		XGA 43Hz*	1024	768/2	35.52	43.48
		XGA 60Hz*	1024	768	48.36	60.00
		XGA 70Hz*	1024	768	56.48	70.07
PC
		XGA 75Hz*	1024	768	60.02	75.03
		XGA 85Hz*	1024	768	68.68	85.00
		SXGA 43Hz*	1280	1024/2	46.43	43.44
		SXGA 60Hz*	1280	1024	63.98	60.02
		SXGA 75Hz*	1280	1024	79.98	75.03
		SXGA 85Hz	1280	1024	91.15	85.02
		SXGA+	1400	1050	64.02	60.00
		UXGA 60Hz	1600	1200	75.00	60.00
	Mac	MAC13	640	480	35.00	66.67
		MAC16	832	624	49.73	74.55
		MAC19	1024	768	60.24	74.93
		MAC21	1152	870	68.68	75.06
	Video	HDTV(1035i) 60Hz			33.75	60.00
		HDTV(1035i) 59Hz			33.72	59.94
		480p	720	483	31.47	59.94
		720p 60Hz	1280	720	45.00	60.00
system		720p 59Hz	1280	720	44.96	59.94
		1080i 60Hz	1920	1080/2	33.75	60.00
		1080i 59Hz	1920	1080/2	33.72	59.94
VIDEO		1080i 50Hz	1920	1080/2	28.125	50
		1080 30SF/30P	1920	1080	33.750	60/30
		1080 25SF/25P	1920	1080	28.125	50/25
		1080 24SF/24P	1920	1080	27.000	48/24
		NTSC			15.734	60
		PAL			15.625	50
		SECAM			15.625	50

•UXGA signals cannot be projected when the screen mode is set to 16:9. (☞ page 31)

•The resolutions for the input signals are listed in the table above.

•Certain types of signals in the frequency range may not be displayed normally.

•When a signal other than those listed above is input, the image could be partially erased or unwanted folds-over the image may appear.

•Some signals other than those listed above can be displayed. However, they may require adjustment.

•Some of the signals listed above may require adjustment depending on the video board used.

•Composite sync (Cs) and G on Sync signals cannot sometimes be handled depending on the devices connected.

•VGA signals from the PC could at times be displayed in the video 480p mode.

(In this case, the projector enters the video menu when the MENU button is pressed.)

20