Telex MS-2002 Headset Microphone Type Selection DIP Switch, Mic Kill Send Enable DIP Switch

Page 11

Headset Microphone Type Selection DIP Switch

SW1-1 applies only to a dynamic-mic headset connected to the dynamic-mic headset jack on the front panel. If the headset specifications indicate the microphone type is balanced, or if you are unsure, leave this switch in the off (default) position. If the specifications indicate an unbalanced microphone, set SW1-1 to on.

NOTE: For best results in noisy environments, a noise canceling (directional or cardioid) microphone is highly recommended. This is especially true if you are using the VOX feature.

Mic Kill Send Enable DIP Switch

The MS-2002 can generate an inaudible signal which turns off the microphones on all intercom stations on a channel (for stations that detect this signal). This feature is useful, for example, when an unattended microphone has been left on and is causing unnecessary noise on a channel. By default, Mic Kill is not enabled.

To activate Mic Kill Send, do the following:

>Set SW1-6to the on position.

Program Interrupt DIP Switches

If you plan on using external program sources with the MS-2002, you have a choice of whether or not you want the program audio to shut off on the intercom channel while you are talking. By default, program audio does not interrupt during talk. You can change this as follows:

>For channel 1 program interrupt during talk, set SW1-7 to on.

OR

For channel 2 program interrupt during talk, set SW1-8 to on.

Incoming Call Beep DIP Switches

If call signal receive is enabled (switches SW1-3 and SW1-5), incoming calls will be indicated by red flashing Call keys. An optional beep tone can also be used. Internal switches enable the beep tone. You can then turn the beep tone on or off via the front panel during normal operation.

To enable the beep tone, do the following:

>Verify the call signal receive DIP switches are on (SW1-3 and SW1-5).

•For incoming call beep in a headset, set SW3-1 to off.

•For incoming call beep in speaker 1, set SW3-1 to off and SW3-3 to on.

•For incoming call beep in speaker 2, set SW3-1 to off and SW3-4 to on.

NOTE: For more information on turning incoming call beeps on or off during operation, see “Incoming Call Beep ON / OFF” on page 14.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Incoming Call Beep DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Program Interrupt DIP SwitchesSettings for Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Direct Program Listen Enable / Disable JumpersExternal Program Input and PA Output MountingConnections Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Test Tone Operation and SpecificationsPower-Up Check MS-2002 Bottom View Sidetone AdjustmentTap the Mic Kill key Voice-Activated Microphone VOX SetupOperation To check and set the VOX level, do the followingTo mute the microphone during talk, do the following To call an intercom channel, do the followingTo turn the program inputs on and off, do the following Using Mic KillPublic Address To use the public address system, do the followingIncoming Call Beep on / OFF Using Voice-Activated Microphone VOXTo enable incoming call beep, do the following General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference
Top Page Image Contents