Telex MS-2002 user manual

Page 15

.

FIGURE 3. MS-2002 Monaural Master Speaker Station Configuration.

Agood configuration for smaller intercom systems when you want to operate the MS-2002 as a master speaker station, with one (1) speaker to monitor both intercom channels. In this configuration, the Combine/Isolate switch is set to the Isolate position. With this setting, the two (2) intercom channels are completely separated. The MS-2002 dip switches are set to monaural operation so that both intercom channels are heard in the speaker.

15

Image 15

Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Incoming Call Beep DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Program Interrupt DIP SwitchesSettings for Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Direct Program Listen Enable / Disable JumpersMounting ConnectionsExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Operation and Specifications Power-Up CheckTest Tone MS-2002 Bottom View Sidetone AdjustmentTap the Mic Kill key Voice-Activated Microphone VOX SetupOperation To check and set the VOX level, do the followingTo mute the microphone during talk, do the following To call an intercom channel, do the followingTo turn the program inputs on and off, do the following Using Mic KillPublic Address To use the public address system, do the followingUsing Voice-Activated Microphone VOX To enable incoming call beep, do the followingIncoming Call Beep on / OFF General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference