Telex user manual MS-2002 Typical Speaker Station and Belt Pack Connections

Page 17

FIGURE 5. MS-2002 Typical Speaker Station and Belt Pack Connections.

Typically, a headset is connected to the front panel of the MS-2002, and the DIP switches are set to the monaural operation (default setting) so both intercom channels are heard in the monaural headphones (binaural headphone operation is not supported).

Beltpacks use less power than speaker stations, and you can daisy-chain more of them on a single cable run. Avoid very long cable runs with daisy-chained speaker stations. This example shows how you would home run a SS-2002 speaker station when the cable is very long. Also, set the Combine/Isolate switch to the Isolate position. With this setting, the two (2) intercom channels are completely separate.

17

Image 17

Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Mic Kill Send Enable DIP Switch Headset Microphone Type Selection DIP SwitchProgram Interrupt DIP Switches Incoming Call Beep DIP SwitchesBalanced Unbalance Switches Monaural or Binaural Operation DIP SwitchesDirect Program Listen Enable / Disable Jumpers Settings for JumpersExternal Program Input and PA Output MountingConnections Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Test Tone Operation and SpecificationsPower-Up Check MS-2002 Bottom View Sidetone AdjustmentOperation Voice-Activated Microphone VOX SetupTo check and set the VOX level, do the following Tap the Mic Kill keyTo mute the microphone during talk, do the following To call an intercom channel, do the followingPublic Address Using Mic KillTo use the public address system, do the following To turn the program inputs on and off, do the followingIncoming Call Beep on / OFF Using Voice-Activated Microphone VOXTo enable incoming call beep, do the following General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference