Telex MS-2002 user manual Important Safety Instructions

Page 3

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Image 3
Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Incoming Call Beep DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Program Interrupt DIP SwitchesSettings for Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Direct Program Listen Enable / Disable JumpersMounting ConnectionsExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Operation and Specifications Power-Up CheckTest Tone MS-2002 Bottom View Sidetone AdjustmentTap the Mic Kill key Voice-Activated Microphone VOX SetupOperation To check and set the VOX level, do the followingTo mute the microphone during talk, do the following To call an intercom channel, do the followingTo turn the program inputs on and off, do the following Using Mic KillPublic Address To use the public address system, do the followingUsing Voice-Activated Microphone VOX To enable incoming call beep, do the followingIncoming Call Beep on / OFF General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference