Telex MS-2002 user manual Quick Reference, Description Action

Page 29

Quick Reference

Description Action

Reset MS-2002 Reset EMS-4001 Test signal on Test signal off Mic latched on Mic latched off Mic momentary on VOX mode on VOX mode off All talk on

All talk off Public address

Mic kill, one channel

Mic kill, all channels

Program ON Program off Audible call alert on Audible call alert off Turn mic kill key off Talk latched on Talk latched off Talk momentary on Talk momentary off Call signal on

Call signal off Receive call signal Listen latched on Listen latched off Listen momentary on

Press All Talk and Listen 1

Press All Talk and Listen 5

Press All Talk and PA, then tap Call Tap Call, then tap any other key

Tap Headset or Panel Mic (key is green) Tap Headset or Panel Mic

Hold Headset or Panel Mic

Tap twice: Headset or Panel Mic Tap Headset or Panel Mic

Hold All Talk when Headset or Panel Mic is lit (All Talk key is green) Release All Talk

Hold PA when Headset or Panel Mic is lit (PA key is green)

Tap Mic Kill, then tap Talk or Listen (Mic Kill key will blink green and the Talk and listen keys are green). Tap Mic Kill to exit

Tap Mic Kill, then tap All Talk (Mic Kill key will blink green and all Talk and Listen keys are green). Tap Mic Kill to exit

Hold Mic Kill, then tap channel’s Talk key (key is green). Tap Mic Kill to exit. Hold Mic Kill, then tap the channel’s talk key. Tap Mic Kill to exit

Hold Mic Kill, then tap either Call (all Call keys are red). Tap Mic Kill to exit Hold Mic Kill, then tap either Call. Tap Mic Kill to exit

Tap Mic Kill

Tap Talk (key is green) Tap Talk

Hold Talk Release Talk Hold Call Release Call

(Call key blinks red) Tap Listen (key is green) Tap Listen

Hold Listen

17

Page 28 Page 30
Image 29
Page 28 Page 30
Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Mic Kill Send Enable DIP Switch Headset Microphone Type Selection DIP SwitchProgram Interrupt DIP Switches Incoming Call Beep DIP SwitchesBalanced Unbalance Switches Monaural or Binaural Operation DIP SwitchesDirect Program Listen Enable / Disable Jumpers Settings for JumpersExternal Program Input and PA Output MountingConnections Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Test Tone Operation and SpecificationsPower-Up Check MS-2002 Bottom View Sidetone AdjustmentOperation Voice-Activated Microphone VOX SetupTo check and set the VOX level, do the following Tap the Mic Kill keyTo mute the microphone during talk, do the following To call an intercom channel, do the followingPublic Address Using Mic KillTo use the public address system, do the following To turn the program inputs on and off, do the followingIncoming Call Beep on / OFF Using Voice-Activated Microphone VOXTo enable incoming call beep, do the following General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference
Top Page Image Contents