Telex MS-2002 user manual Installation, Configuration Pre-check

Page 9

CHAPTER 2

Installation

Configuration Pre-check

Before connecting the MS-2002 make sure it is properly configured for you intended usage. The locations of the configuration switches are shown in Figure 2.

To access internal switches, do the following:

>Remove three (3) screws from the top cover and three (3) screws from the bottom portion of each side.

FIGURE 2. Configuration Jumpers and Switches Location

9

Image 9

Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Mic Kill Send Enable DIP Switch Headset Microphone Type Selection DIP SwitchProgram Interrupt DIP Switches Incoming Call Beep DIP SwitchesBalanced Unbalance Switches Monaural or Binaural Operation DIP SwitchesDirect Program Listen Enable / Disable Jumpers Settings for JumpersMounting ConnectionsExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Operation and Specifications Power-Up CheckTest Tone MS-2002 Bottom View Sidetone AdjustmentOperation Voice-Activated Microphone VOX SetupTo check and set the VOX level, do the following Tap the Mic Kill keyTo mute the microphone during talk, do the following To call an intercom channel, do the followingPublic Address Using Mic KillTo use the public address system, do the following To turn the program inputs on and off, do the followingUsing Voice-Activated Microphone VOX To enable incoming call beep, do the followingIncoming Call Beep on / OFF General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference