Telex MS-2002 user manual Mounting, Connections, External Program Input and PA Output

Page 13

Mounting

The MS-2002 mounts in a standard 19-inch equipment rack and is 1 RU (Rack Unit) high. When mounting the MS-2002, install the supplied black face plates on the appropriate side. The face plates should be mounted with the grooves on the top.

NOTE: You must perform the sidetone adjustment (page 10) after all components are connected. With the MS-2002 being rack mounted, you may not be able to access the sidetone trimmers. In this case, you can position the MS-2002 in the rack and make all required connections. Then, adjust the sidetone trimmers before installing and tightening all rack mount screws.

Connections

Sample connection drawings are shown in figures 3 to 6.

External Program Input and PA Output

Connection for external program input and PA output are shown in Figure 6 on page 18.

REFERENCE: For more information, see the EMS-4001 User Instruction Manual (P/N 9350-7713-000) which can be found at http://www.telexaudiocom.com/manuals.php.

13

Image 13

Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Mic Kill Send Enable DIP Switch Headset Microphone Type Selection DIP SwitchProgram Interrupt DIP Switches Incoming Call Beep DIP SwitchesBalanced Unbalance Switches Monaural or Binaural Operation DIP SwitchesDirect Program Listen Enable / Disable Jumpers Settings for JumpersConnections MountingExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Power-Up Check Operation and SpecificationsTest Tone MS-2002 Bottom View Sidetone AdjustmentOperation Voice-Activated Microphone VOX SetupTo check and set the VOX level, do the following Tap the Mic Kill keyTo mute the microphone during talk, do the following To call an intercom channel, do the followingPublic Address Using Mic KillTo use the public address system, do the following To turn the program inputs on and off, do the followingTo enable incoming call beep, do the following Using Voice-Activated Microphone VOXIncoming Call Beep on / OFF General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference