Telex MS-2002 user manual Contents

Page 5

Table

of

Contents

INTRODUCTION	7
Description	7
Features	8
INSTALLATION	9
Configuration Pre-check	9
Headset Microphone Type Selection DIP Switch	11
Mic Kill Send Enable DIP Switch	11
Program Interrupt DIP Switches	11
Incoming Call Beep DIP Switches	11
Monaural or Binaural Operation DIP Switches	12
Balanced Unbalance Switches	12
Direct Program Listen Enable / Disable Jumpers	12
Mounting	13
Connections	13
External Program Input and PA Output	13
Cables	14
OPERATION AND SPECIFICATIONS	9
Power-Up Check	9
Test Tone	9
Sidetone Adjustment	10
Voice-Activated Microphone (VOX) Setup	11
Operation	11
NORMAL VS. PROGRAMMING MODE	11
VOLUME ADJUSTMENT	12
RECEIVING CALLS	12
CALL AN INTERCOM CHANNEL	12
MICROPHONE MUTE DURING TALK	12
ALL TALK	13
Public Address	13
TURNING THE PROGRAM INPUTS ON AND OFF	13
Using Mic Kill	13
Using Voice-Activated Microphone (VOX)	14
Incoming Call Beep ON / OFF	14
Specifications	15
Quick Reference	17

Image 5

Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Mic Kill Send Enable DIP Switch Headset Microphone Type Selection DIP SwitchProgram Interrupt DIP Switches Incoming Call Beep DIP SwitchesBalanced Unbalance Switches Monaural or Binaural Operation DIP SwitchesDirect Program Listen Enable / Disable Jumpers Settings for JumpersExternal Program Input and PA Output MountingConnections Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Test Tone Operation and SpecificationsPower-Up Check MS-2002 Bottom View Sidetone AdjustmentOperation Voice-Activated Microphone VOX SetupTo check and set the VOX level, do the following Tap the Mic Kill keyTo mute the microphone during talk, do the following To call an intercom channel, do the followingPublic Address Using Mic KillTo use the public address system, do the following To turn the program inputs on and off, do the followingIncoming Call Beep on / OFF Using Voice-Activated Microphone VOXTo enable incoming call beep, do the following General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference