Telex MS-2002 user manual Using Voice-Activated Microphone VOX, Incoming Call Beep on / OFF

Page 26

Using Voice-Activated Microphone (VOX)

If you use VOX, you do not have to insure the microphone key is turned on whenever you want to talk.

To activate VOX, do the following:

1.Verify the Headset and Panel Mic keys are off.

2.If you are using a headset, tap the Headset key twice to turn on headset VOX.

OR

If you are using a panel microphone, tap the Panel Mic key twice to turn on panel mic VOX.

Whichever key you tap, it glows orange when the microphone is off and flickers or turns green when the microphone is off and flickers and turns green when the microphone turns on.

REFERENCE: For more information on VOX adjustment, see “Voice-Activated Microphone (VOX) Setup”, page 14.

Incoming Call Beep ON / OFF

Normally, incoming calls are indicated by red-flashing Call keys.

To enable incoming call beep, do the following:

NOTE: Ensure this feature has been activated via internal switches (page 11).

3.Press and hold the Mic Kill Key for about 2 seconds, then release it.

It should now be lit green to indicate the intercom station is in programming mode.

4.Tap either Call key on the MS-2002 to turn the beep feature on or off.

NOTE: It does not matter which one you tap, since this feature affects both channels.

5.Tap the Mic Kill key to return to normal operation.

14

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Master Station and Power Supply MS-2002See the enclosed warranty card for further details Important Safety Instructions Page Contents Page Introduction DescriptionFeatures MS-2002 Reference ViewInstallation Configuration Pre-checkSwitch # Description Settings Default Program Interrupt DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Incoming Call Beep DIP SwitchesDirect Program Listen Enable / Disable Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Settings for JumpersExternal Program Input and PA Output MountingConnections Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Test Tone Operation and SpecificationsPower-Up Check Sidetone Adjustment MS-2002 Bottom ViewTo check and set the VOX level, do the following Voice-Activated Microphone VOX SetupOperation Tap the Mic Kill keyTo call an intercom channel, do the following To mute the microphone during talk, do the followingTo use the public address system, do the following Using Mic KillPublic Address To turn the program inputs on and off, do the followingIncoming Call Beep on / OFF Using Voice-Activated Microphone VOXTo enable incoming call beep, do the following Specifications General Power RequirementsSpeaker Output Output Level Quick Reference Description Action
Top Page Image Contents