Telex MS-2002 user manual Introduction, Description

Page 7

CHAPTER 1

Introduction

Description

The MS-2002 is a complete 2-channel master station and system power supply (24VDC, 2Amps total power) in a single unit. Simply plug it into any AC power outlet from 100 to 240 volts, add a microphone or headset, connect intercom stations to the back panel, and you’re ready to communicate. It has both 1- and 2-channel connectors, so you do not have to add a separate breakout box if you want to mix 1- and 2-channel stations. The MS-2002 fits in a standard 19-inch equipment rack and is one

(1)rack unit high. The basic MS-2002 can communicate with two (2) intercom channels. This number can be increased by connecting optional EMS-4001 Expansion Stations. Each EMS-4001 adds four (4) addition channels, and up to four (4) of these expansion stations can be connected for a total of 18 channels.

7

Image 7

Contents MS-2002 Master Station and Power SupplySee the enclosed warranty card for further details Important Safety Instructions Page Contents Page Description IntroductionMS-2002 Reference View FeaturesConfiguration Pre-check InstallationSwitch # Description Settings Default Incoming Call Beep DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Program Interrupt DIP SwitchesSettings for Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Direct Program Listen Enable / Disable JumpersConnections MountingExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Power-Up Check Operation and SpecificationsTest Tone MS-2002 Bottom View Sidetone AdjustmentTap the Mic Kill key Voice-Activated Microphone VOX SetupOperation To check and set the VOX level, do the followingTo mute the microphone during talk, do the following To call an intercom channel, do the followingTo turn the program inputs on and off, do the following Using Mic KillPublic Address To use the public address system, do the followingTo enable incoming call beep, do the following Using Voice-Activated Microphone VOXIncoming Call Beep on / OFF General Power Requirements SpecificationsSpeaker Output Output Level Description Action Quick Reference