Telex MS-2002 user manual

Page 18

FIGURE 6. External Audio Input and PA Output.

You can connect two (2) audio sources to the Program Inputs connector: one (1) for each channel. Audio sources can be directly connected with a user-supplied DB9M connector. For more information on the program input connector specifications, see “Specifications” on page 15. However, a more convenient method is to use an XP-USPG Breakout Panel as shown. The XP-USPG also interfaces the PA jack of the MS-2002 to a standard, 2-pin XLR audio cable.

NOTE: The SP-USPG Breakout Panel can be rack mounted using a BOP-1000 Rack Mount Plate.

18

Image 18

Contents Master Station and Power Supply MS-2002See the enclosed warranty card for further details Important Safety Instructions Page Contents Page Introduction DescriptionFeatures MS-2002 Reference ViewInstallation Configuration Pre-checkSwitch # Description Settings Default Program Interrupt DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Incoming Call Beep DIP SwitchesDirect Program Listen Enable / Disable Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Settings for JumpersMounting ConnectionsExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Operation and Specifications Power-Up CheckTest Tone Sidetone Adjustment MS-2002 Bottom ViewTo check and set the VOX level, do the following Voice-Activated Microphone VOX SetupOperation Tap the Mic Kill keyTo call an intercom channel, do the following To mute the microphone during talk, do the followingTo use the public address system, do the following Using Mic KillPublic Address To turn the program inputs on and off, do the followingUsing Voice-Activated Microphone VOX To enable incoming call beep, do the followingIncoming Call Beep on / OFF Specifications General Power RequirementsSpeaker Output Output Level Quick Reference Description Action